Application of Selected Reverse Engineering Procedures Based on Specific Requirements

Abstract

Abstract The paper describes a solution of reverse engineering tasks using the equipment of the laboratory of the Technical University in Zvolen. The first task was linked to evaluation of a wear rate of the tool used to for mulching and elimination of unwanted wood or weed vegetation. The obtained data will be used as a base line for determination of the time interval for the tool replacement. We developed a prototype of components and their drawing documentation for a single-purpose machine for cutting barley. We created the 3D model using the method of photogrammetry. The finished drawing documentation and prototypes were handed over to the company KRUP. Finally, we identified the most suitable procedures for creating a model of a part with a complex shape. We tested the techniques of editing the point cloud processing, as well as of smoothing the surfaces and automating the creation of partial geometric elements of the model. Based on the properties of the component, which is the starting point of the entire reverse engineering process and from the achieved results, we set recommendations for the selection of appropriate procedures.