In vitro study of optimal removable partial denture clasp design made from novel high-performance polyetherketoneketone

Abstract

Purpose: This study aimed to investigate the retentive force and deformation of double Akers’ polyetherketoneketone (PEKK) clasps on removable partial dentures (RPDs) with varying designs and undercut depths.

Methods: Thirty double Akers’ PEKK clasps with two different widths and heights (Groups I and II) were fabricated using computer-aided design and computer-aided manufacturing (CAD/CAM). Each design was further subdivided (n = 5) into three undercut depths (0.25, 0.50, and 0.75 mm). The retentive force of the clasps was measured after 10 years of clinical use (15,000 insertion/removal cycles), and the deformation of the clasp tips was analyzed before and after cycling.

Results: Clasps with 0.50-mm and 0.75-mm undercut depths exhibited greater initial retentive forces (3.15–3.51 N) compared to those in the 0.25-mm undercut group (2.40–2.80 N). Group I maintained consistent retentive forces over the cycles (P = 0.345), whereas Group II showed declining forces after the initial use (P < 0.003). In both groups, the 0.50-mm undercut exhibited a greater retentive force than the 0.25-mm (P < 0.001 and P < 0.004, respectively), with no significant differences between the 0.50-mm and 0.75-mm undercut depths. Despite a lower initial retentive force, the 0.25-mm undercut showed less deformation and clasp tip wear.

Conclusions: The PEKK clasps did not exhibit significantly reduced retentive forces or permanent deformations after 15,000 fatigue cycles. These results suggest that the PEKK polymer displays superior mechanical properties as an esthetic clasp material, and clasps with 0.50-mm and 0.75-mm undercut depths are recommended for long-term clinical use.