Influence of custom dynamic orthoses on tibiotalar joint reaction force and contact stress: A cadaveric study

Abstract

Post-traumatic osteoarthritis (PTOA) often develops following tibial pilon fractures. Evidence suggesting PTOA development is driven by elevated articular contact stress from residual malreduction has led surgeons to strive for precise articular reduction, typically at the cost of extended operative time. Post-operative bracing using carbon fiber custom dynamic orthoses (CDOs) offers another means to decrease tibiotalar joint reaction force (JRF) and contact stress. The purpose of this cadaveric study was to measure how CDO stiffness influences ankle JRF and contact stress over the stance phase of gait.

A servohydraulic load frame was used to test five cadaver ankles, with axial loading (240–330 N) and pneumatic actuation of the Achilles tendon (50–436 N) serving to quasi-statically model multiple points in the stance phase of gait. Three CDO rotational stiffness conditions were tested: (1) No CDO–0 Nm/deg, (2) low stiffness CDO–1.8 Nm/deg, and (3) moderate stiffness CDO–2.3 Nm/deg. JRF and contact stresses were measured using a piezoresistive pressure sensor inserted into the tibiotalar joint. An insole plantar pressure sensor placed between the cadaveric foot and CDO footplate measured limb/device interactions via the plantar center of pressure (COP).

As limb loading progressed through stance, the plantar COP progressed from hindfoot to forefoot, as it would in normal gait. Both CDOs demonstrated decreases in JRF, reaching as high as 32% for the low CDO and 26% for the moderate CDO, with associated decreases in contact stress. This suggests that post-operative bracing could lessen PTOA risk after pilon fractures.