Experimental and Computational Heat Transfer Study of SCO2 Single-Jet Impingement

Abstract This study experimentally and computationally investigates the heat transfer capability of supercritical carbon dioxide (sCO2) single jet impingement. The evaluated jet Reynolds number range is between 80000 and 600000, with a non-dimensional jet-to-target surface spacing of 2.8. CO2 impinging jet stagnation conditions were maintained at approximately 200 bar and 400°C for most experiments. The goal is to understand how changes in the aforementioned parameters influence heat transfer between the working fluid and the heated surface. Additionally, due to the elevated Reynolds numbers and difference in thermodynamic properties between air and CO2, air derived impingement correlations may not be appropriate for CO2 impingement; these correlations are evaluated against experimental sCO2 data. At the time of this study, no sCO2 impingement data was available relevant to sCO2 power cycles. The target surface is a 1.5- inch diameter copper block centered on the 3 mm orifice. At the bottom of the copper block, a mica heater provides a uniform heat flux. Thermocouples embedded in the copper block are used to determine the surface temperature. The Nusselt numbers from experimental sCO2 data and air derived area averaged correlations are compared. The comparisons showed that air correlations drastically underpredict the heat transfer when sCO2 is used as the working fluid. A modified sCO2 correlation using experimental data at discussed conditions, is derived based on an existing air correlation. A CFD study is also performed to further investigate sCO2 heat transfer characteristics, and assess the applicability to this problem type.