Enhancement of the quality of mc-Si ingot grown by vacuum directional solidification furnace with growth rate increase reducing the cost of the wafer for PV application: Carbon and oxygen analysis

In this paper, we propose a numerical model to investigate the dissolution of oxygen atoms from the porous silica crucible, SiO gas formation, back diffusion of CO gas and segregation of carbon and oxygen during the growth of multi-crystalline silicon (mc-Si) by vacuum directional solidification (VDS) at different growth rates (3, 6 and 9 mm/h) by silt valve opening rate. The dissolution of oxygen decreases during the rapid growth of ingot because the reaction between the molten silicon and the porous silica crucible is constrained. This limitation on oxygen dissolution from the porous silica crucible further diminishes chemical reaction inside the VDS furnace. Consequently, the segregation pattern of the carbon and oxygen is affected at higher growth rate. During the VDS mc-Si growth, a growth rate of 9mm/h yields better quality of the VDS grown mc-Si ingots compared to other growth rates, this rate reduces SiC precipitation and SiO₂ cluster formation due to lower concentration of carbon and oxygen. The obtained carbon concentration minimizes the wire saw defects. Based on these numerical results (9 mm/h), we have implemented experimental work. Prepared samples are analyzed using FTIR spectra and minority carrier lifetime measurements. The effect of oxygen concentration in the samples is analyzed in the minority carrier lifetime measurements. The oxygen and carbon concentrations are calculated by FTIR spectra and their results are compared with the numerical simulation.