B Nidheesh Kumar, M C Santhosh Kumar, A Mercy Latha, Sachinlal Aroliveetil, M Nallaperumal, Krishnan Balasubramaniam, S Remakanthan, K K Moideenkutty, Shyam S Nair, L Mohan Kumar
{"title":"Thickness measurement of polychlorotrifluoroethylene coating over metallic seal using terahertz time-domain spectroscopy","authors":"B Nidheesh Kumar, M C Santhosh Kumar, A Mercy Latha, Sachinlal Aroliveetil, M Nallaperumal, Krishnan Balasubramaniam, S Remakanthan, K K Moideenkutty, Shyam S Nair, L Mohan Kumar","doi":"10.1080/10589759.2023.2274020","DOIUrl":null,"url":null,"abstract":"ABSTRACTPolychlorotrifluoroethylene is used as a coating material over metallic seals in low-temperature applications to arrest fluid leakage from the impeller side in turbopumps. Typically, polychlorotrifluoroethylene coating is applied on V-type seals, with a thickness ranging from 80 to 130 μm by spraying an emulsion over the substrate followed by heat treatment. An attempt has been made to measure the polychlorotrifluoroethylene coating thickness over V-type seals using terahertz time-domain spectroscopy in reflection geometry, a noncontact, non-invasive NDT method. When the terahertz pulse from a transmitter photo-conductive antenna is incident on the V-type seal, it penetrates through the polychlorotrifluoroethylene coating. It gets reflected from the coating/base coat interface. Here, the reflected echoes from the air-to-polychlorotrifluoroethylene coating interface and polychlorotrifluoroethylene coating to the basecoat interface get overlapped in the time domain as the polychlorotrifluoroethylene coating layer is very thin. The sparse deconvolution technique separates the individual reflected signals and obtains the time delay signals from various interfaces. From the estimation of time delay values, the thickness of the coating has been computed using the refractive index value extracted using terahertz time-domain spectroscopy in transmission mode before the reflection measurements. The obtained thickness values are in close agreement with the coating thickness measured using optical microscopy.KEYWORDS: PolychlorotrifluroethyleneThz time-domain spectroscopythickness estimationreflection geometryseal AcknowledgmentsWe would like to thank Shri. Srirangam Siripothu and their team at PCM/VSSC for the support offered in sample preparation.Disclosure statementNo potential conflict of interest was reported by the author(s).Data availability statementThe data supporting this study’s findings are available from the corresponding authors upon reasonable request. No third-party data has been used for this research work.Additional informationFundingThe author(s) reported that there is no funding associated with the work featured in this article.","PeriodicalId":49746,"journal":{"name":"Nondestructive Testing and Evaluation","volume":"62 3-4","pages":"0"},"PeriodicalIF":3.0000,"publicationDate":"2023-11-01","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"Nondestructive Testing and Evaluation","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.1080/10589759.2023.2274020","RegionNum":3,"RegionCategory":"材料科学","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q2","JCRName":"MATERIALS SCIENCE, CHARACTERIZATION & TESTING","Score":null,"Total":0}
引用次数: 0
Abstract
ABSTRACTPolychlorotrifluoroethylene is used as a coating material over metallic seals in low-temperature applications to arrest fluid leakage from the impeller side in turbopumps. Typically, polychlorotrifluoroethylene coating is applied on V-type seals, with a thickness ranging from 80 to 130 μm by spraying an emulsion over the substrate followed by heat treatment. An attempt has been made to measure the polychlorotrifluoroethylene coating thickness over V-type seals using terahertz time-domain spectroscopy in reflection geometry, a noncontact, non-invasive NDT method. When the terahertz pulse from a transmitter photo-conductive antenna is incident on the V-type seal, it penetrates through the polychlorotrifluoroethylene coating. It gets reflected from the coating/base coat interface. Here, the reflected echoes from the air-to-polychlorotrifluoroethylene coating interface and polychlorotrifluoroethylene coating to the basecoat interface get overlapped in the time domain as the polychlorotrifluoroethylene coating layer is very thin. The sparse deconvolution technique separates the individual reflected signals and obtains the time delay signals from various interfaces. From the estimation of time delay values, the thickness of the coating has been computed using the refractive index value extracted using terahertz time-domain spectroscopy in transmission mode before the reflection measurements. The obtained thickness values are in close agreement with the coating thickness measured using optical microscopy.KEYWORDS: PolychlorotrifluroethyleneThz time-domain spectroscopythickness estimationreflection geometryseal AcknowledgmentsWe would like to thank Shri. Srirangam Siripothu and their team at PCM/VSSC for the support offered in sample preparation.Disclosure statementNo potential conflict of interest was reported by the author(s).Data availability statementThe data supporting this study’s findings are available from the corresponding authors upon reasonable request. No third-party data has been used for this research work.Additional informationFundingThe author(s) reported that there is no funding associated with the work featured in this article.
期刊介绍:
Nondestructive Testing and Evaluation publishes the results of research and development in the underlying theory, novel techniques and applications of nondestructive testing and evaluation in the form of letters, original papers and review articles.
Articles concerning both the investigation of physical processes and the development of mechanical processes and techniques are welcomed. Studies of conventional techniques, including radiography, ultrasound, eddy currents, magnetic properties and magnetic particle inspection, thermal imaging and dye penetrant, will be considered in addition to more advanced approaches using, for example, lasers, squid magnetometers, interferometers, synchrotron and neutron beams and Compton scattering.
Work on the development of conventional and novel transducers is particularly welcomed. In addition, articles are invited on general aspects of nondestructive testing and evaluation in education, training, validation and links with engineering.