The Impact of Upstream Static Deformation on Flow Past a Cylinder/Flare

Abstract

Reynolds-averaged Navier–Stokes simulations are performed for supersonic turbulent flow over a cylinder/flare with upstream surface distortion representative of structural deformation induced via fluid–structural and fluid–thermal–structural behavior. Broad parametric analysis is carried out through the generation of Kriging-response surfaces from a database of general simulations. A posteriori simulations are then carried out at parametric combinations that correspond to extrema in the Kriging response surfaces to gain deeper insights into the interaction between the surface distortion and flow responses. Upstream distortions tend to decrease, rather than increase, the peak pressure and heat flux loads on the flare compared to an undeformed cylinder. Furthermore, decreases in these quantities reach up to O(10%) compared to up to O(1%) for increases. Integrated quantities over the flare are relatively insensitive to upstream distortion. The corner separation length is the most sensitive quantity to upstream distortion, with protrusions tending to increase the separation length and recessions reducing the separation length. Modifications in the separation length of up to 40% are observed. Reductions in peak loads tend to correspond to increases in the corner separation length. The movement of the surface distortion relative to the corner indicates a negligible impact beyond 1.5 distortion lengths from the corner, and the largest impact on the corner separation length occurs when distortion is directly adjacent. These results are an important step toward understanding and quantifying the impact of surface deformations on downstream components.