Lag Plot: A Novel Method to Determine Viable Bacterial Cell Number via a Single OD Measurement.

Abstract

Bactericidal activity is a valuable parameter which is considered and measured for antimicrobial compounds. The available standard protocol to evaluate bactericidal activity is based on the direct colony count. Colony counting requires serial dilution, plating, overnight incubation, and direct counting, which is time-and labor-intensive. In regard to eliminate direct plate count, novel techniques were developed based on the real-time growth monitoring which can come with some limitations and drawbacks. These drawbacks encourage us to develop a novel technique with simple procedure to determine viable bacterial cell count. In this procedure, real-time growth monitoring is not required. In fact, after an incubation time, the number of viable bacteria can be determined with a single OD measurement and through an equation. In this regard, four standard bacterial strains, including Staphylococcus aureus (ATCC 25923), Escherichia coli (ATCC 25922), Pseudomonas aeruginosa (ATCC 27853), and Bacillus subtilis (ATCC 23857), were cultured with descending inoculum densities (1.5 × 10⁷ to 15 CFU/mL) and growth curves were drawn. As expected, growth in the samples with lower inoculum densities recorded with longer lag phase. Also, a direct relation was observed between the recorded turbidities and initial cell counts. A logarithmic curve (lag plot) was obtained by plotting the OD, after 12-18 h incubation, against initial cell counts. In all examined strains, R² was calculated in the range of 0.96-0.99 which is acceptable value for coefficient of determination. Equation corresponding to the lag plot was obtained and called lag equation. This equation is applicable to calculate the number of viable cells in unknown samples simply by inoculation, incubation, and single OD measurement. Developed technique can be introduced as a simple substitution for labor- and time-intensive direct colony counting.