Construction and demolition waste as a low-cost adsorbent for water treatment: kinetics, isotherm, thermodynamics, and Fenton regeneration.

Abstract

The present study proposes to investigate the feasibility of using construction and demolition waste (CDW) as an aqueous remediation agent through adsorption. The CDW, with and without chemical and thermal pre-activation, was evaluated to remove the methylene blue (MB) dye from the water solution. Variables interfering with adsorption processes, such as adsorbent dosage, solution pH, and particle size, were evaluated. The material was characterized by pH_ZPC, FTIR, XRD, SEM, EDS, and TG. The kinetic and equilibrium data better fitted the Elovich and Sips models, respectively. A maximum adsorption capacity of 18.62 mg g^-1 at 60 °C was observed. Thermodynamic data indicated that adsorption occurred through a spontaneous and favorable process governed mainly by physical processes. The regeneration studies were carried out using processes based on the Fenton reaction, where the catalytic action of the iron naturally present in the CDW was evaluated. The results showed that the desorption balance was the main limiting factor for the effective regeneration of the saturated material. Adding Fe²⁺ to the system made this process suitable for the regeneration of the CDW and degradation of the pollutant in the aqueous phase. A regeneration efficiency of 65%, maintained practically constant during five adsorption-regeneration cycles, was observed. These results highlight the high potential of using CDWs as an adsorbent material.