Available bone is the foremost criterion in the insertion of endosteal implants.

Abstract

The foremost criterion in the insertion of endosteal implants is bone availability. Implant dentists should consider first the amount of available bone of the edentulous ridge where the endosteal implant will be inserted. A common error and cause of many implant failures is the dentist's use of an implant modality which is not indicated for the density and morphology of the available bone in the edentulous ridge. Implant modality/system is not the primary criterion in the insertion of endosteal implants. Before the dentist inserts an endosteal implant, he should gauge or measure the amount of bone where the implant is intended to be placed. It should be measured in width, height, length, trajectory, and implant-crown ratio. After recording the measurements of the available bone, these should be placed in different categories to serve as guides in implant selection. If there is not enough bone for the endosteal implant, bone modification should be performed. This can be done either by osteoplasty or ridge augmentation with the use of bone grafting materials. Aside from the amount of available bone in the edentulous ridge, another very, very important thing that should be considered is the quality or its density. Any biocompatible implant demonstrates some osseointegrated surfaces depending upon the bone type into which it is placed and the loads placed upon it. Implant body must exhibit a macrogeometry suitable for acceptable levels of force transfer to the surrounding tissues as well as for implantation into a bony site of a particular anatomic size.