Development of a new rotating photocatalytic reactor for the degradation of hazardous pollutants

Abstract

Abstract The aim of this study was to develop a new rotating photocatalytic reactor operating in recirculation mode with light sources placed outside the photoreactor vessel. The photoreactor with cylindrical geometry was equipped with four artificial lamps used to simulate solar irradiation (2.4% UVB and 12% UVA; 300–700 nm). The photocatalyst was immobilized on abrasive material used as a support and placed on the central (inner) photoreactor tube, which was connected to a power-driven shaft that allowed rotation at a desired speed. A suitable modification of the commercial TiO2 P25 photocatalyst was carried out to reduce its band gap energy and electron-hole recombination and to extend the visible light response range of TiO2. The main task of this research was to apply the basic principles of process intensification methodology, i.e. to explore the influence of rotational hydrodynamics, which allows good access of reactants to the photocatalyst surface, good irradiation of the photocatalytic surface and reduction of mass transfer resistance, leading to increased process efficiency. The homemade photoreactor was used for the photocatalytic degradation of one of the major types of neonicotinoid insecticides, acetamiprid. The influence of various working conditions, such as initial solution pH, rotation speed, recirculation flow rate and initial concentration of acetamiprid on the photocatalytic degradation process was investigated. The optimum degradation conditions were found at a recirculation flow rate of 200 cm3 min−1 and a rotation speed of 200 rpm, indicating that the mass transfer process strongly contributes to the photocatalytic degradation rate at the conditions used in this study. The results obtained during the photocatalytic degradation of acetamiprid in a rotating photoreactor were compared with those obtained under similar operating conditions in a flat-plate photoreactor, and the corresponding conclusions were drawn based on the performed kinetic analysis.