Method of creation of power sources for home appliances under constraints of limited resources

Abstract

The subject of study in this article is the voltage ranges, methods, and tools for prototyping independent sources of power supply and artificial lighting for home appliances with reuse of only widespread components. The goal is to improve the efficiency of the creation and use of independent power supply sources for home appliances. Task: to analyze the history of the development of voltage standards for households; analyze existing autonomous power sources and types of batteries; analyze different loads; find rational voltage ranges based on fundamental values; analyze charge control and balancing circuits for lithium-based batteries; propose the technique of prototyping independent sources of power supply based on reused lithium-ion (Li-ion) accumulators; provide an example of the practical application of the results of research. According to the tasks, the following results were obtained. The evolution of voltage standards of electrical supply networks is analyzed. Types of autonomous power supplies, including pure sine versions, are discussed. The analysis of batteries for autonomous power sources of different chemical compositions is performed. It is proposed to use the water analogy of current and area as an analogy of battery capacity for visual representation of electrical processes. Models of constant current consumption and constant power consumption are considered. It is proposed to reduce the internal resistance of the battery assembly by parallel connection of the reused lithium-ion accumulators. Correspondence of voltage ranges of sequential connection of lithium-ion cells to ensure compatibility with existing devices is investigated. Rational parameters of voltage ranges to ensure compatibility of lithium-ion and acid accumulators with the ability to charge directly from solar panels without a charge controller are found. Charge controllers, battery management systems (BMS), and battery balancing circuits are analyzed. A set of steps for reuse of lithium-ion accumulators for the creation of autonomous power sources is proposed. Conclusions. The main contribution of this research is the proposed method of creation of power supply and interior lighting based on the reuse of accumulators without additional components. The discovered and proposed magic numbers of 3, 5, 7, 9, 11 and 13 for series connection of lithium-ion cells allows to obtain the equivalent of standard voltage ranges of 12 V, 19 V, 27 V, 36 V, 42 V and 48 V. The proposed technique of adjusting the voltage of the passive balancer allows adding 4.5 % to the capacity of the battery assembly. The described solutions allow to build the completely scalable autonomous low-voltage electrical supply network with the ability to charge directly from solar panels without expensive charge controllers.