Analysis of Behaviour of the Steel Arch Support in the Geological and Mining Conditions of the Cam Pha Coal Basin, Vietnam

Abstract

In recent years, the Vietnamese coal mining industry has observed a dynamic increase in both its production and efficiency. In Vietnam, the most precious type of coal is anthracite, which is found in the Quang Ninh province. Industrial anthracite deposits are estimated to be over 2 billion Mg. At present, coal deposits are extracted mostly by the underground method. Coal production is gradually increasing in the underground mines in the Quang Ninh area and it is expected to constitute about 75% of the country’s total coal production in 2030. This involves an increase in the number and length of underground workings. Cam Pha is the largest coal basin of Vietnam, located in the Quang Ninh province. So far, the yearly length of underground workings driven in underground mines in the Cam Pha basin is roughly 90÷150 km. About 84 % of these underground workings are supported by the steel arch support made of SWP profile. A similar situation can be observed in Russia, Ukraine, China, India and Turkey. In addition, the average length of repaired underground workings in the Cam Pha basin constitutes approximately 30% of the total length driven . The main cause was reported is loss of underground workings stability. This requires significant material and labour costs as well as the cost of replacing damaged elements. Additionally, it disturbs the continuity of the mining operations. This article presents the results of the numerical modelling of the rock mass around underground workings driven in typical geo-mining conditions for underground coal mines in the Cam Pha basin, supported by the steel arch support made of SWP and V profiles. As a result of the conducted analyses, the range of failure zone of the rock mass around underground workings and the distribution of reduced stress in the steel arch support elements were determined. The effort states of the steel arch support made of SWP22 profile and V21 profile were compared. The simulations considered different inclinations angle of coal seam, following the structure of the rock mass in the Cam Pha basin. The analysis was carried out using the based-finite difference method code, FLAC2D. Based on the obtained results, actions for improving the stability of underground workings driven in the underground mines of the Cam Pha basin were proposed.