Soot Formation in Diesel Combustion under High-EGR Conditions

C. Idicheria, L. Pickett
{"title":"Soot Formation in Diesel Combustion under High-EGR Conditions","authors":"C. Idicheria, L. Pickett","doi":"10.4271/2005-01-3834","DOIUrl":null,"url":null,"abstract":"Experiments were conducted in an optically accessible constant-volume combustion vessel to investigate soot formation at diesel combustion conditions - in a high exhaust-gas recirculation (EGR) environment. The ambient oxygen concentration was decreased systematically from 21% to 8% to simulate a wide range of EGR conditions. Quantitative measurements of in-situ soot in quasi-steady n-heptane and No.2 diesel fuel jets were made by using laser extinction and planar laser-induced incandescence (PLII) measurements. Flame lift-off length measurements were also made in support of the soot measurements. At constant ambient temperature, results show that the equivalence ratio estimated at the lift-off length does not vary with the use of EGR, implying an equal amount of fuel-air mixing prior to combustion. Soot measurements show that the soot volume fraction decreases with increasing EGR. The regions of soot formation are effectively 'stretched out' to longer axial and radial distances from the injector with increasing EGR, according to the dilution in ambient oxygen. However, the axial soot distribution and location of maximum soot collapses if plotted in terms of a 'flame coordinate', where the relative fuel-oxygen mixture is equivalent. The total soot in the jet cross-section at the maximum axial soot location initially increases and then decreasesmore » to zero as the oxygen concentration decreases from 21% to 8%. The trend is caused by competition between soot formation rates and increasing residence time. Soot formation rates decrease with decreasing oxygen concentration because of the lower combustion temperatures. At the same time, the residence time for soot formation increases, allowing more time for accumulation of soot. Increasing the ambient temperature above nominal diesel engine conditions leads to a rapid increase in soot for high-EGR conditions when compared to conditions with no EGR. This result emphasizes the importance of EGR cooling and its beneficial effect on mitigating soot formation. The effect of EGR is consistent for different fuels but soot levels depend on the sooting propensity of the fuel. Specifically, No.2 diesel fuel produces soot levels more than ten times higher than those of n-heptane.« less","PeriodicalId":21404,"journal":{"name":"SAE transactions","volume":"03 1","pages":"1559-1574"},"PeriodicalIF":0.0000,"publicationDate":"2005-10-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"186","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"SAE transactions","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.4271/2005-01-3834","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"","JCRName":"","Score":null,"Total":0}
引用次数: 186

Abstract

Experiments were conducted in an optically accessible constant-volume combustion vessel to investigate soot formation at diesel combustion conditions - in a high exhaust-gas recirculation (EGR) environment. The ambient oxygen concentration was decreased systematically from 21% to 8% to simulate a wide range of EGR conditions. Quantitative measurements of in-situ soot in quasi-steady n-heptane and No.2 diesel fuel jets were made by using laser extinction and planar laser-induced incandescence (PLII) measurements. Flame lift-off length measurements were also made in support of the soot measurements. At constant ambient temperature, results show that the equivalence ratio estimated at the lift-off length does not vary with the use of EGR, implying an equal amount of fuel-air mixing prior to combustion. Soot measurements show that the soot volume fraction decreases with increasing EGR. The regions of soot formation are effectively 'stretched out' to longer axial and radial distances from the injector with increasing EGR, according to the dilution in ambient oxygen. However, the axial soot distribution and location of maximum soot collapses if plotted in terms of a 'flame coordinate', where the relative fuel-oxygen mixture is equivalent. The total soot in the jet cross-section at the maximum axial soot location initially increases and then decreasesmore » to zero as the oxygen concentration decreases from 21% to 8%. The trend is caused by competition between soot formation rates and increasing residence time. Soot formation rates decrease with decreasing oxygen concentration because of the lower combustion temperatures. At the same time, the residence time for soot formation increases, allowing more time for accumulation of soot. Increasing the ambient temperature above nominal diesel engine conditions leads to a rapid increase in soot for high-EGR conditions when compared to conditions with no EGR. This result emphasizes the importance of EGR cooling and its beneficial effect on mitigating soot formation. The effect of EGR is consistent for different fuels but soot levels depend on the sooting propensity of the fuel. Specifically, No.2 diesel fuel produces soot levels more than ten times higher than those of n-heptane.« less
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
高egr工况下柴油燃烧烟尘的形成
在光学可及的等体积燃烧容器中进行了实验,以研究柴油在高废气再循环(EGR)环境下燃烧条件下烟灰的形成。环境氧浓度从21%系统地降低到8%,以模拟大范围的EGR条件。采用激光消光和平面激光诱导白炽灯(PLII)测量方法对准稳定正庚烷和2号柴油射流中的原位烟尘进行了定量测量。火焰上升长度的测量也支持烟灰的测量。在恒定的环境温度下,结果表明,在升离长度处估计的等效比不随EGR的使用而变化,这意味着燃烧前的燃料-空气混合量相等。烟尘测量结果表明,烟尘体积分数随EGR的增大而减小。根据周围氧气的稀释度,随着EGR的增加,烟灰形成区域有效地“延伸”到距离喷油器更长的轴向和径向距离。然而,轴向煤烟分布和最大煤烟的位置如果用“火焰坐标”来绘制,其中相对燃料-氧气混合物是等效的。当氧浓度从21%降至8%时,最大轴向烟灰位置射流截面上的总烟灰先增加后进一步减小至零。这一趋势是由烟尘形成速率和增加的停留时间之间的竞争引起的。由于燃烧温度较低,随着氧浓度的降低,烟尘的形成率降低。同时,烟灰形成的停留时间增加,使烟灰有更多的时间积聚。与无EGR工况相比,将环境温度提高到标称柴油机工况以上会导致高EGR工况下油烟的快速增加。这一结果强调了EGR冷却的重要性及其对减少烟尘形成的有益作用。EGR对不同燃料的影响是一致的,但煤烟水平取决于燃料的排烟倾向。具体来说,2号柴油产生的烟尘比正庚烷高出十倍以上。«少
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
自引率
0.00%
发文量
0
期刊最新文献
Increasing aeronautic electric propulsion performances by cogeneration and heat recovery Time and spatially resolved temperature measurements of a combusting diesel spray impinging on a wall Physical Properties of Bio-Diesel and Implications for Use of Bio-Diesel in Diesel Engines Control Strategies for Peak Temperature Limitation in DPF Regeneration Supported by Validated Modeling Drivers Involved in Crashes Killing Older Road Users
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1