Mass Bias Corrections for Hydrogen and Oxygen Isotope Analysis of Tourmaline by Secondary Ion Mass Spectrometry

Hydrogen (δ2H) and oxygen (δ18O) stable isotopes are used to trace fluid sources, metals, and contaminants in the environment and Earth's subsurface. Tourmaline-supergroup minerals provide an opportunity to quantify both δ2H and δ18O from the same grain using in situ analytical techniques (e.g., Secondary Ion Mass Spectrometry – SIMS). These minerals occur in a wide variety of geological environments and have a wide range of chemical compositions. However, large differences in chemical composition are problematic during SIMS analysis, as instrumental mass fractionation (IMF) often varies with the chemical composition of the mineral. Therefore, calibration models derived by analyzing tourmalines of different chemical composition must be developed for accurate analysis by SIMS. Hydrogen and oxygen isotope analysis was done on six reference tourmaline samples using a CAMECA 7f SIMS instrument operating at extreme energy filtering. Spot-to-spot repeatability for tourmalines was in the range 4–5‰ and 0.6–1.0‰ for δ2H and δ18O, respectively. There is a strong correlation between IMF and several elements (B, Si, Ca, Fe, and Fe#). Iron content is the most robust predictor of IMF, and we report two calibration curves for the correction of δ2H and δ18O measured by SIMS using reference tourmaline crystals with different Fe contents, ranging from 0.00 to 14.00 wt.% Fe. This is the first calibration curve used to correct for the fractionation of hydrogen isotope ratios in tourmaline as measured by SIMS. Tourmaline-supergroup minerals require a suite of at least three, with a range of Fe content, to ensure accurate and precise H and O analysis by SIMS. Crystallographic orientation effects were not observed for these tourmalines.