Anisortopic Modeling of Hydraulic Fractures Height Growth in the Anadarko Basin

Correct estimation of hydraulic fracture height growth is a critical step in the design of Hydraulic Fracturing (HF) treatment, as it maximizes the reservoir stimulation and returns on investment. The height of the fractures is governed by several in situ conditions, especially stress variation with depth. The common workflow to estimate stress is by building the mechanical earth model (MEM) and calibrating it using the Diagnostic Fracture Injection Test (DFIT). However, DFIT interpretation is a complex task, and depending on the method used, different results may be obtained that will consequently affect the predicted hydraulic fracture height. This work used the tangent and compliance methods for DFIT interpretation, along with isotropic and anisotropic stress profiles, to estimate the HF height growth using numerical modeling in a 3D planar HF simulator. Data from two wells in the Anadarko Basin were used in this study. The predicted height was compared with microseismic data. The results showed that even though the tangent method fits better to the isotropic stress profile, HF did not match with the microseismic data. On the contrary, the anisotropic stress profile showed a good match between the compliance DFIT model and the microseismic events. Based on the discussions presented in this study, the validity of the DFIT interpretation is debatable, and when the formations are anisotropic, the isotropic model fails to correctly estimate the minimum stress profile, which is the main input for the estimation of the fracture height. This is in addition to the fact that some researchers have questioned the use of the tangent method in low-permeability formations.