Effects of Flow Pulsation and Surface Geometry On Heat Transfer Performance in a Channel with Teardrop-shaped Dimples Investigated by Large Eddy Simulation

Large eddy simulation was performed to investigate heat transfer performance of a pulsating flow over teardrop-shaped dimples. A total of six geometries of dimpled surfaces were examined for dimple arrangements of in-line/staggered/original and dimple inclination angle of 0-60 deg. Pulsating flows were generated by sinusoidally varying the volume-averaged velocity. The pulsation frequency and amplitude were changed for the Strouhal number of 0-0.60 and the root-mean-square velocity amplitude normalized by the bulk flow velocity of 0-0.14. The results showed that the surface-averaged Nusselt number and friction factor were larger for the pulsating flow case than those for the steady flow case. The surface-averaged Nusselt number ratio and the friction factor increased with the Strouhal number up to the Strouhal number of 0.30. For the Strouhal number larger than 0.30, they decreased with the Strouhal number or stayed almost constant. Consequently, the heat transfer efficiency index increased with the Strouhal number. The increase in the local Nusselt number ratio due to the flow pulsation was observed at the leading-edge region of the dimples. The results of the streamlines near the dimple showed that the swirling separation bubble was located closer to the leading-edge region due to the pulsation, which resulted in the increase of the absolute values of the turbulent heat flux and the local Nusselt number ratio.