Improving Efficiency of Heat Pump Dryer Using R32 Refrigerant by Nanofluid

Drying process are important in many areas in the agriculture and food sectors, including increasing shelf life, improving transportability by reducing product weight or adding value to products. However, the main problem in the drying process is the relatively high energy consumption. Therefore, the development of energy-saving dryers is necessary. Based on the above reasons, this research aims to study the performance enhancement of heat pump dryers using R32 refrigerant by using heat recovery and nanofluid. The heat that is exhausted from the refrigerant by a heat exchanger. In this work, a Nano titanium dioxide (Ti2O3) was selected. Pork was dried under the conditions of drying temperature of 45, 50 and 55 °C and water flow rate in the heat exchanger at the front of the drying chamber of 2, 3 and 4 L/min. Criteria for evaluating heat pump dryer performance include drying rate, specific moisture extraction rate, specific energy consumption, heat pump dryer performance coefficient compared to heat pump dryers without nanofluid. The results showed that increasing the drying temperature and water flow rate in heat exchanger increased the drying rate, power and specific moisture extraction rate in the heat pump dryer using nanofluid. Whereas, the specific energy consumption was lower than the case without nanofluid. Increasing the drying temperature and the water flow rate in the heat exchanger had relatively little effect on the coefficient of performance (COP) of the heat pump dryer. Moreover, the study found that the coefficient of performance of heat pump dryer with nanofluid was in the range of 4.33 - 4.42.