Discrete element model for effective electrical conductivity of spark plasma sintered porous materials

This paper aims to analyse electrical conduction in partially sintered porous materials using an original resistor network model within discrete element framework. The model is based on sintering geometry, where two particles are connected via neck. Particle-to-particle conductance depends on neck size in sintered materials. Therefore, accurate evaluation of neck size is essential to determine conductance. The neck size was determined using volume preservation criterion. Additionally, grain boundary correction factor was introduced to compensate for any non-physical overlaps between particles, particularly at higher densification. Furthermore, grain boundary resistance was added to account for the porosity within necks. For numerical analysis, the DEM sample was generated using real particle size distribution, ensuring a heterogeneous and realistic microstructure characterized by a maximum-to-minimum particle diameter ratio of 15. The DEM sample was subjected to hot press simulation to obtain geometries with different porosity levels. These representative geometries were used to simulate current flow and determine effective electrical conductivity as a function of porosity. The discrete element model (DEM) was validated using experimentally measured electrical conductivities of porous NiAl samples manufactured using spark plasma sintering (SPS). The numerical results were in close agreement with the experimental results, hence proving the accuracy of the model. The model can be used for microscopic analysis and can also be coupled with sintering models to evaluate effective properties during the sintering process.