Evolution of pre-damaged ITER grade plasma facing components under WEST plasma exposure: smoothing and tungsten sources

The evaluation of the impact of plasma-facing units (PFUs) damage on subsequent plasma operation is an important issue for ITER. This is one of the topic addressed by the operation of dedicated PFUs in WEST. From the start of WEST in 2017, few ITER grade divertor plasma-facing units (PFUs) were tested in the lower divertor for short plasma exposure (experimental campaigns C1-C5). A PFU is an assembly of tungsten blocks on CuCrZr tube via pure copper interlayer. Since 2022, WEST operates with a lower divertor fully equipped with ITER grade PFUs (experimental campaign C6-C7) with long duration plasma exposure capabilities. To test the ageing of the ITER-grade PFUs on an accelerated basis, well controlled damage was implemented on purpose with electron beam loading on the plasma facing surface of two different PFUs (pre-damage#1 and #2 featuring different level of damage). Damage tackled in this study is induced by the loading with numerous transient heat loading events to mimic the ELM impact on the ITER grade PFU. This paper presents the damage before and after WEST plasma exposure and shows the tungsten sources and temperature of the block measured during the operation. On damaged area, surface roughening is heterogeneous. With WEST campaigns (C3, C4 and C7) respectively ended in (2018, 2019 and 2023) a global smoothing of the pre-damaged surfaces, in particular those located in the high loaded erosion area, is observed. No evolution of the crack is observed in the electron beam loaded area, while new cracking are observed on non pre-damaged area on the tungsten top surfaces in highly loaded areas (outer strike point) after significant plasma duration and cumulated energy (first observation in C4 and tends to be confirmed with preliminary observations after the C7 campaign). Smoothing is less pronounced after the 2018 campaign, which may be due to the related short plasma duration. The surface smoothing of blocks also depends on their poloidal position. For PFU which has no shaping, toroidal positioning within a block has no influence on the surface smoothing. After 2019 and 2023 campaigns, equivalent relative smoothing is obtained (between 19 and 32%). For the explored plasma conditions, damage has no influence on the maximum brightness of W.