Repair of heat load damaged plasma–facing material using the wire-based laser metal deposition process

Due to its unique properties tungsten is a promising candidate as plasma-facing-material (PFM) in future nuclear fusion reactors. Tungsten features an exceptionally high melting point, high thermal conductivity, low tritium inventory and comparatively low erosion rate under plasma loading [1]. But given the extreme loads on the PFM during operation of a fusion reactor, the lifetime of plasma-facing components (PFC)s is limited. Currently, it is planned to replace damaged PFCs when they reach the end of their service life. However, the lifetime of PFCs could be increased by in situ repair using additive manufacturing technology (AM) in the form of direct-energy-deposition (DED). The wire–based laser metal deposition process (LMD-w) meets several necessary conditions for operation in the vessel and could be used for performing such in situ repairs.

It was investigated if the LMD-w process is able to heal thermal induced surface cracks and roughening by remelting the substrate during deposition of tungsten. For this purpose, tungsten samples of 12 × 12 × 5 mm³, which later served as substrate plates for the LMD-w experiments, were treated with combined steady-state and transient thermal loads in the electron beam facility JUDITH 2. These samples were brazed to a copper cooling structure and exposed to 10⁵ thermal shocks of 0.5 ms duration and an intensity of L_abs = 0.55 GW m⁻² (F_HF = 12 MW s^0.5 m⁻²) at a base temperature of T_base = 700 °C. This way, edge localized mode (ELM) like thermal load damage was induced on the tungsten samples. On these samples, different LMD-w and laser remelting process strategies were performed. Subsequently, these samples were analyzed, and it was examined that the healing of the pre-damaged substrate material was successful. In parallel, the laser remelting process was modeled in a thermal transient finite element method (FEM) simulation in order to gain an insight into the temperatures prevailing in the material during the process.