Experimental investigation of machining nimonic-80A alloy on wire EDM using response surface methodology

This paper aims to optimize the wire electric discharge machining (WEDM) parameters using multi response surface methodology. Experiments were performed on Nimonic 80A alloy to improve the response variables, namely material removal rate (MRR) and Kerf width (K_w). SEM analysis was carried out on the different samples obtained using different levels of input input parameters, namely, peak current, gap voltage, duty cycle and wire speed to evaluate the quality of machined surface. The influence of these parameters on MRR and K_w were determined using ANOVA. The analysis results revealed that the peak current is the main factor affecting MRR and K_w. The optimized WEDM parameters obtained using multi response function of RSM technique for machining of Nimonic 80A alloy are peak current (57A), gap voltage (90 V), duty cycle (75 µs), and wire speed (7 mm/min) of wire electrode. The characterization results show that high discharge energy results in deep craters with micro craters at low energy levels on the machined surface of the specimen. The results obtained using the proposed methodology would provide sufficient data for enhancing the machining of Nimonic 80A alloy on WEDM.