Evaluation of the HMA performance using combined effects of marble waste dust filler and superpave aggregate gradation

ABSTRACT During the fabrication of new products, a variety of wastes discharged and stored by causing harsh environmental problems. The marble processing plant is amongst the industrial sector that produces huge waste. Thus, the main purpose of this study is to evaluate the combined effects of marble waste dust filler and Superpave aggregate gradation on the performance of HMA. Based on the Marshall Mix design, seventy-two (72) specimens were produced from three below-restricted zone (BRZ) of Superpave gradation (BRZ4, BRZ5, & BRZ6) by using the 0.45 power chart. The design gradation obtained to be BRZ5 with 4.96% OBC with corresponding values 9.13 KN of stability, 2.96 mm of flow, 73.51% of VFA, 15.73% of VMA, 2.308 gm/cm3, of bulk density and 4% of air void. The crushed stone dust filler was partially replaced by Marble Waste Dust filler (under No. 200 sieve) at replacement rate of (1%, 1.5, 2, 2.5, 3, 3.5, 4, 4.5 and 5%) by keeping design gradation and OBC constant. The test showed satisfactory results. The Marshall mix design parameters of all mixtures are within specification limit under international and local specifications. Marble waste dust filler when blended with a BRZ of Superpave gradation indicated a substantial effect on Marshall stability with 10.18 KN value at 3% MWD filler content.