A moving wave implementation in WRF to study the impact of surface water waves on the atmospheric boundary layer

While numerous modeling studies have focused on the interaction of ocean surface waves with the atmospheric boundary layer, most employ idealized waves that are either monochromatic or synthetically generated from a theoretical wave spectrum, and the atmospheric solvers are typically incompressible. To study wind–wave coupling in real-world scenarios, a model that can simulate both realistic meteorological and wave conditions is necessary. In this paper we describe the implementation of a moving bottom boundary condition into the Weather Research and Forecasting model for large-eddy simulation applications. We first describe the moving bottom boundary conditions within WRF’s pressure-based vertical coordinate system. We then validate our code with idealized test cases that have analytical solutions, including flow over a monochromatic wave with and without viscosity. Finally, we present results from turbulent flows over a moving monochromatic wave with different wave ages, and demonstrate satisfactory agreement of the wave growth rate with results from the literature. We also compare atmospheric stress and wind parameters from two physically equivalent cases. The first specifies a wind moving in the same direction as a propagating wave, while the second involves a stationary wave with the wind adjusted such that the wind relative to the wave is the same as in the first case. Results indicate that the velocity and Reynolds stress profiles for the two cases match, further validating the moving bottom implementation.