Shale Hydrocarbon Development Based on Drill Cuttings & TOC Analysis: Case Study of Brownshale Drill Cuttings of Well BS-03, Pematang Formation, Bengkalis Trough, Central Sumatra Basin

Brownshale is a lithology unit in the middle of the Pematang Formation consisting of brown to black shale that is deposited in the lacustrine environment. Brownshale from the results of previous studies stated as the main source rock in the Central Sumatra Basin, which is spread over several troughs, namely Balam, Aman, Rangau, Kiri, and Bengkalis Troughs, where Bengkalis Trough is the most extensive Trough. In the shale hydrocarbon prospecting analysis, Brownshale from previous researchers concluded that it had good prospects, based on several parameters including: TOC values with poor to very good quality. Brownshale formation is a type of kerogene as kerogen type of II/III, brittleness index greater than 0.48, and rock compressive strength below 10,000 Psi. One method in the development phase of shale hydrocarbon is to determine the fracable sweetspot window using drill cuttings and TOC, because there is no core data available. Based on the results of the well log analysis of well BS-03, it is obtained information that the Brownshale formation has a thickness of 1028 feet with intercalation laminated shale/sand section, so the mineral content varies greatly. From the ternary diagram of XRD (bulk analysis) results of drill cuttings of Brownshale formation of well BS-03, it can be seen that mineral distribution of Quartz-Clay-Calcite (Q-C-C) is spread between zone 1 to zone 3, namely: Dominant Quartz - Minor Clay & Carbonate (Zone 1: Brittle Quartz Rich), Dominant Carbonate - Quartz & Minor Clay (Zone 2: Brittle Carbonate Rich), and Quartz & Carbonate Balance - Clay minor (Zone 3: Ductile, hard to frac). This shows that not all Brownshale formation intervals are easy to frac (high fracability). From the XRD result, percentage of mineral content (bulk analysis) of Brownshale drill cuttings, there is an interesting phenomenon, i.e. the presence of sillimanite and kaliophilite minerals significantly starting at a depth of 10,780 ft and below, where both minerals have tenacity: brittle, and also from the results of the MBT analysis seen an interesting phenomenon, i.e. at a depth interval of about 10,780 ft the value of CEC drops below 3 meq/100 grams, and can be categorized as the brittle shale. Referring to the presence of sillimanite and kaliophilite minerals, as well as low MBT values, then at intervals of 10,780 ft below, it can be seen that at the bottom of the depth interval as a fracable sweetspot window, and at the upper depth interval of the Brownshale formation, it is believed to be a fracture barrier.