Effect of storage time on the chemical composition of whole and grainless corn plant silage harvested at different maturity stages

- The objective of this study was to evaluate the effect of harvesting corn at different maturity stages for silage production combined with four storage periods, considering nutrient loss and the chemical composition of silage of the whole plant and also of grainless plants. The experiment was performed in a completely randomized design with a factorial arrangement of six maturity stages of corn [reproductive (R); R1 to R6] and four periods of silage storage (30, 60, 90, and 120 days). At stages R1 and R2, losses by effluents occurred more intensely when compared with the more advanced stages, whereas losses by gases showed the opposite behavior, with stage R6 responsible for the greatest losses. Stage R4 showed a stable dry matter (DM) content during the storage period, 42.08%, and had the lowest levels of neutral detergent fiber (NDF), acid detergent fiber (ADF), and acid detergent lignin (ADL) for the whole plant silage. The ADL in the silage of grainless plant of stage R4 was not the lowest, but it was close to the first reproductive stages, being an important point, since the first reproductive stages can present a vegetative fraction of better quality. The highest DM volumes produced by area occurred in the most advanced stages; however, R5 obtained a greater reduction in volume over the days of storage (20.66 kg day −1 ). The production cost was lower at the advanced stages (R4, R5, and R6) when compared with the first reproductive stages (R1, R2, and R3), and in general, during the storage period the costs did not have great variations. Based on the chemical composition of the silages, DM losses during the storage period, the stability in the costs of DM ton over the days of storage, the R4 stage was the most suitable for silage production. from 1 to 6 R1 – start of grain filling, 88 days after emergence; stage R2 – milky 99 days after emergence; stage R3 – pasty grain, 124 days after emergence; R4 – hard dough grain, 142 days after emergence; R5 – dent grain, 149 days after R6 – grain at 156 days after 120 days), for for