A variable supply, (2.3-2.7)GHz linear power amplifier module for IEEE 802.16e and LTE applications using E-mode pHEMT technology

Y. Chow, C. K. Yong, Joan Lee, H.K. Lee, J. Rajendran, S. Khoo, M.L. Soo, C. Chan
{"title":"A variable supply, (2.3-2.7)GHz linear power amplifier module for IEEE 802.16e and LTE applications using E-mode pHEMT technology","authors":"Y. Chow, C. K. Yong, Joan Lee, H.K. Lee, J. Rajendran, S. Khoo, M.L. Soo, C. Chan","doi":"10.1109/MWSYM.2008.4632971","DOIUrl":null,"url":null,"abstract":"This paper describes the design and realization of a linear power amplifier for the IEEE 802.16e and UMTS LTE applications operating at the (2.3-2.7)GHz band. The power amplifier comprises a MMIC that uses a proprietary 0.25um enhancement-mode pHEMT technology with integrated output matching inside the module. When tested using a 10MHz bandwidth IEEE802.16e signal with 64-QAM modulation, the amplifier exhibits a linear power output of (23 -24)dBm across the full (2.3-2.7)GHz band with less than 2.5% EVM on a single 3.3V supply while at least 26dBm is typically available with a 5V supply. Efficiency is typically (15-17)% with this supply range. A 20dB bypass gain attenuator that is activated by a CMOS-compatible voltage pin is included on-chip. Output power detection is achieved by the use of an on-chip power detector and a bias shutdown voltage shuts down the complete amplifier. The complete module is packaged in a molded chip-on-board (MCOB) 5mm x 5mm module.","PeriodicalId":273767,"journal":{"name":"2008 IEEE MTT-S International Microwave Symposium Digest","volume":"125 1","pages":"0"},"PeriodicalIF":0.0000,"publicationDate":"2008-06-15","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"1","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"2008 IEEE MTT-S International Microwave Symposium Digest","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.1109/MWSYM.2008.4632971","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"","JCRName":"","Score":null,"Total":0}
引用次数: 1

Abstract

This paper describes the design and realization of a linear power amplifier for the IEEE 802.16e and UMTS LTE applications operating at the (2.3-2.7)GHz band. The power amplifier comprises a MMIC that uses a proprietary 0.25um enhancement-mode pHEMT technology with integrated output matching inside the module. When tested using a 10MHz bandwidth IEEE802.16e signal with 64-QAM modulation, the amplifier exhibits a linear power output of (23 -24)dBm across the full (2.3-2.7)GHz band with less than 2.5% EVM on a single 3.3V supply while at least 26dBm is typically available with a 5V supply. Efficiency is typically (15-17)% with this supply range. A 20dB bypass gain attenuator that is activated by a CMOS-compatible voltage pin is included on-chip. Output power detection is achieved by the use of an on-chip power detector and a bias shutdown voltage shuts down the complete amplifier. The complete module is packaged in a molded chip-on-board (MCOB) 5mm x 5mm module.
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
可变电源,(2.3-2.7)GHz线性功率放大器模块,用于IEEE 802.16e和LTE应用,采用E-mode pHEMT技术
本文介绍了一种用于(2.3-2.7)GHz频段的IEEE 802.16e和UMTS LTE应用的线性功率放大器的设计和实现。功率放大器包括一个MMIC,该MMIC采用专有的0.25um增强模式pHEMT技术,模块内部集成了输出匹配。当使用64-QAM调制的10MHz带宽IEEE802.16e信号进行测试时,该放大器在整个(2.3-2.7)GHz频段的线性输出功率为(23 -24)dBm,在单个3.3V电源下EVM小于2.5%,而在5V电源下通常可获得至少26dBm。在此供应范围内,效率通常为(15-17)%。一个20dB旁路增益衰减器,由cmos兼容的电压引脚激活,包括在芯片上。输出功率检测是通过使用片上功率检测器和偏置关断电压关闭整个放大器来实现的。完整的模块封装在模制的MCOB (chip-on-board) 5mm × 5mm模块中。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
自引率
0.00%
发文量
0
期刊最新文献
Design and performance of a single band 1X2 RF front end module for mobile WiMAX applications A new method for determining the characteristic impedance Zc of transmission lines embedded in symmetrical transitions On design of a low power wireless hearing aid communication system Equivalent circuit model to explain extraordinary transmission A miniature lumped element LTCC bandpass filter with high stopband attenuation for GPS applications
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1