Mechanical Properties of Indentation in Plasma Nitrided and Nitrocarburized Austenitic Stainless Steel AISI 321

Abstract

Austenitic stainless steels are widely used due to their resistance to corrosion and to the possibility of using them at temperatures above 600 °C. Plasma nitriding and nitrocarburizing consist of a thermochemical process that introduces nitrogen and nitrogen/carbon, in atomic form, allowing the formation of second phases of these elements with the substrate. These thermochemical treatments of plasma nitriding and nitrocarburizing were performed on austenitic stainless steel AISI 312 at temperatures of 400 °C and 500 °C, obtaining thicknesses of around 12 μm and 24 μm, respectively. Mechanical properties of indentation were obtained using a Hit 300 nanoindenter (Anton Paar), in a load-unload cycle and with a depth of up to 10% of the layer, with Berkovich indenter. The elastic moduli obtained for the nitrided layers were 281 ± 21 GPa (400 °C) and 163 ± 32 GPa (500 °C) and for the nitrocarburized were 214 ± 12 GPa (400 °C) and 169 ± 25 GPa (500 °C). The indentation nanohardness obtained for the nitrided layers were 14.1 ± 1.0 GPa (400 °C) and 3.5 ± 1.2 GPa (500 °C) and for the nitrocarburized layers were 10.8 ± 0.8 GPa (400 °C) and 4.3 ± 1.2 GPa (500 °C). Therefore, these results indicate slightly higher values for the two mechanical properties indentation (elastic modulus and nanohardness) at 400 °C than at 500 °C caused by nitriding compared to nitrocarburizing treatment; however, when considering the percentages of standard deviations, the treatments at 500 °C present much higher values for these properties, as compared to the treatments at 400 °C, a behavior associated with the presence of chromium and iron nitrides.