Design Modification and Comparative Analysis of Glycol‐Based Natural Gas Dehydration Plant

Abstract

Natural gas production from reservoirs is often associated with water, which poses numerous challenges, such as methane hydrate formation, sludge, corrosion, and flow assurance issues in gas processing plants and sales gas transmission pipelines. To effectively remove water from natural gas, there is a need to design, compare, and modify dehydration plants. This study investigated the performance difference between a conventional Triethylene Glycol (TEG)‐based dehydration system with a cooler at the TEG inlet to the contactor, and a newly proposed TEG‐based dehydration system with a heat exchanger replacing the cooler at the TEG inlet with the contactor. The advanced process simulation software Aspen HYSYS was used to design and compare two dehydration system configurations. The modified design configuration exhibited better performance in terms of energy conservation and water‐removal capability. The material balance of molar flow, mass flow, and volume flow of dry gas produced in the absorber/contactor column showed a higher volume of dry gas produced in the modified system configuration, indicating that it is a better design. The modified design configuration also produced dry gas within the recommended temperature range for underground storage and transmission. There was a significant difference in the percentage difference of 64% between the conventional and modified designs in terms of energy consumption, whereas the percentage differences of 0% and 0.6% showed non‐significant and significant differences between the two plant design configurations. Both plant design configurations showed a significant reduction (from 0.005 mol% to 0.0002 mol%) in the water composition of natural gas after the simulation.This article is protected by copyright. All rights reserved.