Effect of printing technology, layer height, and orientation on assessment of 3D-printed models

Abstract

Background

Three-dimensional (3D) printing technologies have become popular in orthodontics. The aim of this study is to determine the effect of printing technology, orientation, and layer height on the accuracy of 3D-printed dental models.

Methods

The maxillary arch of a post-treatment patient was scanned and printed at different orientations (0°, 90°) and layer thicknesses (25 µm, 50 µm, 100 µm, and 175 µm) using two different printing technologies (digital light processing and stereolithography). The 120 models were digitally scanned, and their average deviation from the initial model was analyzed using 3D algorithm. A multivariable linear regression analysis was used to estimate the effect of all variables on the average deviation from the initial model for the common layer thicknesses (50/100 µm). Finally, one-way ANOVA and Tukey posthoc test was used to compare the stereolithography (SLA) 25 µm and digital light processing (DLP) 175 µm groups with the groups that showed the least average deviation in the former analysis.

Results

The multivariable linear regression analysis showed that the DLP 50 µm (mean ± SD: −0.022 ± 0.012 mm) and 100 µm (mean ± SD: −0.02 ± 0.009 mm) horizontally printed models showed the least average deviation from the initial model. Finally, the DLP 175 µm horizontally printed models (mean ± SD: 0.015 ± 0.005 mm) and the SLA 25 µm horizontally (mean ± SD: 0.011 ± 0.005 mm) printed models were more accurate.

Conclusions

All the models showed dimensional accuracy within the reported clinically acceptable limits. The highest accuracy was observed with DLP printer, 175 µm layer thickness, and horizontal orientation followed by SLA printer, 25 µm layer thickness, and horizontal orientation.