Performance of high capacity socketed H-piles with long rock socket

Abstract

The pile capacity is commonly calculated by the engineers as the lesser of its structural capacity and the ultimate resistance of ground supporting it using a generalized equation irrespective of the shaft type, socket diameter, socket length, rock type and grout strength. This equation may be over-simplified and risky if the pile/grout/rock interaction is not considered. Based on the loading tests of 6 instrumented socketed piles with 4–6 m rock socket by others and 35 non-instrumented socketed H-piles with 5–34 m rock socket by the author, the load-transfer mechanism in long rock socket is found dependent not only on the mobilization of shear resistance in soil and rock layers, but also largely on the steel/grout bond behavior. A side resistance distribution factor α_s is introduced as a simple and practical index to represent the load-transfer mechanism along the pile shaft and to the socket. It would increase with an increase in loading and pile length in soils, but decrease with an increase in socket length indicating that critical socket length does exist which is likely depending on the grout bond strength. Average bond stress reduces with increased socket length when the critical socket length is exceeded. Residual settlement is largely due to the slip and bond failure at the interface. Creep settlement is largely affected by the properties of grout mix and tends to increase with increased socket length.