Influence of physical properties and shear rate on static liquefaction of saturated loess

Abstract

Flow sliding instability of saturated loess slopes is a common geological hazard in loess areas of China. Previous studies have found that the occurrence of flow-slip loess landslides is closely related to static liquefaction and is controlled by physical characteristics and load conditions. In this work, we comprehensively study these influences of physical properties (i.e. initial pore structure, gradation, dry density) and shear rate on the static liquefaction of saturated loess through a series of consolidated undrained triaxial tests, and the effect mechanism of these related factors on the static liquefaction of saturated loess are also discussed. The results present that: (1) The peak deviator stress and the maximum pore pressure of the undisturbed loess are much greater than these of the remodeled one under each level of confining pressure (except 450 kPa). Further, the calculated liquefaction potential index (LPI) of undisturbed loess is much greater, indicating that undisturbed loess is more prone to static liquefaction due to the initial pore structure. (2) The lower the relative clay/silt content ratio of the saturated remodeled loess, the stronger the potential liquefaction ability. With the increase of the relative content of clay from 0.125 to 0.698, the stress-strain curve gradually transitions from strain softening to hardening. (3) The remodeled loess show the steady-state strength tends to continuously increase with the increase of dry density from 1.38 g/cm³ to 1.56 g/cm³, while the LPI increases first and then decreases, and the largest value appears when the dry density reaches to 1.44 g/cm³. The reason is that the value of 1.44 g/cm³ is the normal consolidated condition, which essentially reflects the potential liquefaction change during the transformation from under consolidated to over consolidated state.(4) The effect of shear rate on the stress-strain curve of remolded loess is not significant, but the peak strength and ultimate pore pressure show a trend of increasing and then decreasing with the increase of shear rate. There exists a “critical shear rate “of 0.1 mm/min reflecting the liquefaction of loess is more likely to occur when reaches to this critical value. (5) Based on the comparison of static liquefaction tests, the influencing factors of static liquefaction of saturated loess are: initial pore structure> gradation > dry density > shear rate. This study can provide a systematic evaluation for understanding the influencing factors of static liquefaction capacity of saturated loess (especially remolded one), and also has a reference for explaining the loess flow-sliding failure mechanism under disturbance conditions.