Temperature of burning iron microparticles with in-situ resolved initial sizes

IF 5.8 2区 工程技术 Q2 ENERGY & FUELS Combustion and Flame Pub Date : 2024-09-19 DOI:10.1016/j.combustflame.2024.113737
Daoguan Ning, Tao Li, Benjamin Böhm, Andreas Dreizler
{"title":"Temperature of burning iron microparticles with in-situ resolved initial sizes","authors":"Daoguan Ning,&nbsp;Tao Li,&nbsp;Benjamin Böhm,&nbsp;Andreas Dreizler","doi":"10.1016/j.combustflame.2024.113737","DOIUrl":null,"url":null,"abstract":"<div><p>Simultaneous, <em>in-situ</em>, optical diagnostics are performed to measure initial diameters and the temporal temperature evolution of iron microparticles burning in hot laminar oxidizing atmospheres with 10–30<!--> <!-->vol% O<span><math><msub><mrow></mrow><mrow><mn>2</mn></mrow></msub></math></span>. The pre-ignition particle diameter and temperature evolution during combustion are monitored using synchronized high-speed diffuse backlight-illumination and two-color pyrometry techniques, respectively. Average temperature histories are obtained for particles sorted into three size fractions centered at 40, 45, and 50<!--> <!--> <span><math><mi>μ</mi></math></span>m with a span of 5<!--> <!--> <span><math><mi>μ</mi></math></span>m. Increasing the oxygen level from 10 to 30<!--> <!-->vol%, particles burn faster and reach a higher peak temperature that increases approximately from 2400 to 3200<!--> <!-->K. From their temperature trajectories, the peak temperatures of individual particles are extracted and correlated with their initial diameters. It is observed that the maximum particle temperature decreases with the increasing particle diameter, attributed to the enlarged radiative and evaporative heat losses relative to the chemical heat release of the larger particles that burn in the diffusion-limited regime. In addition, the size dependence of the maximum particle temperature enhances considerably when the particle peak temperature increases from approximately <span><math><mrow><mn>2400</mn><mspace></mspace></mrow></math></span>K to around <span><math><mrow><mn>2800</mn><mspace></mspace></mrow></math></span>K, but its further variation is small as the particle peak temperature continues approaching the boiling point of the particles. This observation does not align with previous non-size-resolved measurements that have lower temporal resolutions and wider particle size distributions. Possible reasons for this inconsistency are discussed. A theoretical analysis is performed to quantitatively reveal the role of surface radiation and evaporation in the size dependence of the particle peak temperature. The results suggest that at relatively low particle temperatures the size dependence is determined mainly by radiation and that the effect of evaporation becomes more dominant at higher particle temperatures. Moreover, with increasing particle temperature, radiation strengthens the size dependence of the particle peak temperature. On the contrary, evaporation weakens the size dependence at higher temperatures because of the increasing sensitivity of vapor pressure (evaporative heat loss) to the temperature according to Clausius–Clapeyron relation.</p><p><strong>Novelty and significance statement</strong></p><p>This work presents, for the first time, the simultaneous, <em>in-situ</em> measurements of the initial sizes and time-resolved temperatures of micrometer-sized iron particles burning at elevated gas temperatures. Using current size-resolved measurements, particle-temperature evolutions for several particle diameters are statistically obtained with significantly increased precision. This high-fidelity experimental database over a wide range of operating conditions is a very valuable reference for the iron fuel community to validate and improve numerical models of iron particle combustion. Due to the novel design of the experiment, in this work negative correlations between the initial diameters and the maximum temperatures of isolated burning iron particles are observed and theoretically explained. This result does not align with previous non-size-resolved measurements that have lower temporal resolutions and wider particle size distributions.</p></div>","PeriodicalId":280,"journal":{"name":"Combustion and Flame","volume":"270 ","pages":"Article 113737"},"PeriodicalIF":5.8000,"publicationDate":"2024-09-19","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"https://www.sciencedirect.com/science/article/pii/S0010218024004462/pdfft?md5=7f71944ceaddeadd9eaa34f556327590&pid=1-s2.0-S0010218024004462-main.pdf","citationCount":"0","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"Combustion and Flame","FirstCategoryId":"5","ListUrlMain":"https://www.sciencedirect.com/science/article/pii/S0010218024004462","RegionNum":2,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q2","JCRName":"ENERGY & FUELS","Score":null,"Total":0}
引用次数: 0

Abstract

Simultaneous, in-situ, optical diagnostics are performed to measure initial diameters and the temporal temperature evolution of iron microparticles burning in hot laminar oxidizing atmospheres with 10–30 vol% O2. The pre-ignition particle diameter and temperature evolution during combustion are monitored using synchronized high-speed diffuse backlight-illumination and two-color pyrometry techniques, respectively. Average temperature histories are obtained for particles sorted into three size fractions centered at 40, 45, and 50  μm with a span of 5  μm. Increasing the oxygen level from 10 to 30 vol%, particles burn faster and reach a higher peak temperature that increases approximately from 2400 to 3200 K. From their temperature trajectories, the peak temperatures of individual particles are extracted and correlated with their initial diameters. It is observed that the maximum particle temperature decreases with the increasing particle diameter, attributed to the enlarged radiative and evaporative heat losses relative to the chemical heat release of the larger particles that burn in the diffusion-limited regime. In addition, the size dependence of the maximum particle temperature enhances considerably when the particle peak temperature increases from approximately 2400K to around 2800K, but its further variation is small as the particle peak temperature continues approaching the boiling point of the particles. This observation does not align with previous non-size-resolved measurements that have lower temporal resolutions and wider particle size distributions. Possible reasons for this inconsistency are discussed. A theoretical analysis is performed to quantitatively reveal the role of surface radiation and evaporation in the size dependence of the particle peak temperature. The results suggest that at relatively low particle temperatures the size dependence is determined mainly by radiation and that the effect of evaporation becomes more dominant at higher particle temperatures. Moreover, with increasing particle temperature, radiation strengthens the size dependence of the particle peak temperature. On the contrary, evaporation weakens the size dependence at higher temperatures because of the increasing sensitivity of vapor pressure (evaporative heat loss) to the temperature according to Clausius–Clapeyron relation.

Novelty and significance statement

This work presents, for the first time, the simultaneous, in-situ measurements of the initial sizes and time-resolved temperatures of micrometer-sized iron particles burning at elevated gas temperatures. Using current size-resolved measurements, particle-temperature evolutions for several particle diameters are statistically obtained with significantly increased precision. This high-fidelity experimental database over a wide range of operating conditions is a very valuable reference for the iron fuel community to validate and improve numerical models of iron particle combustion. Due to the novel design of the experiment, in this work negative correlations between the initial diameters and the maximum temperatures of isolated burning iron particles are observed and theoretically explained. This result does not align with previous non-size-resolved measurements that have lower temporal resolutions and wider particle size distributions.

查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
原位解析初始尺寸的铁微颗粒燃烧温度
在 10-30 Vol% O2 的热层流氧化气氛中燃烧的铁微粒的初始直径和时间温度演变进行了同步的原位光学诊断测量。点火前的颗粒直径和燃烧过程中的温度变化分别采用同步高速漫反射照明技术和双色高温计技术进行监测。获得了以 40、45 和 50 μm 为中心、跨度为 5 μm 的三个粒度分级的颗粒的平均温度历史记录。将氧气含量从 10% 增加到 30%,颗粒的燃烧速度更快,达到的峰值温度也更高,大约从 2400 K 增加到 3200 K。据观察,颗粒的最高温度随着颗粒直径的增大而降低,这是由于相对于在扩散受限状态下燃烧的较大颗粒的化学热释放,辐射和蒸发热损失增大所致。此外,当颗粒峰值温度从 2400K 左右升高到 2800K 左右时,最大颗粒温度的大小依赖性显著增强,但当颗粒峰值温度继续接近颗粒的沸点时,其进一步变化很小。这一观察结果与以往时间分辨率较低、粒度分布较广的非粒度分辨测量结果不一致。本文讨论了造成这种不一致的可能原因。进行了理论分析,以定量揭示表面辐射和蒸发在颗粒峰值温度的尺寸依赖性中的作用。结果表明,在相对较低的颗粒温度下,粒度相关性主要由辐射决定,而在较高的颗粒温度下,蒸发的影响变得更加主要。此外,随着颗粒温度的升高,辐射加强了颗粒峰值温度的尺寸依赖性。与此相反,根据克劳修斯-克拉皮戎关系,蒸发会减弱在较高温度下的粒度依赖性,因为蒸气压力(蒸发热损失)对温度的敏感性不断增加。利用当前的尺寸分辨测量方法,可以统计出若干直径颗粒的温度演变过程,并显著提高了精确度。这个在广泛操作条件下的高保真实验数据库对于铁燃料界验证和改进铁颗粒燃烧的数值模型非常有参考价值。由于实验设计新颖,在这项工作中观察到了孤立燃烧的铁颗粒的初始直径和最高温度之间的负相关关系,并对其进行了理论解释。这一结果与以往时间分辨率较低、粒度分布较广的非粒度分辨测量结果并不一致。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
Combustion and Flame
Combustion and Flame 工程技术-工程:化工
CiteScore
9.50
自引率
20.50%
发文量
631
审稿时长
3.8 months
期刊介绍: The mission of the journal is to publish high quality work from experimental, theoretical, and computational investigations on the fundamentals of combustion phenomena and closely allied matters. While submissions in all pertinent areas are welcomed, past and recent focus of the journal has been on: Development and validation of reaction kinetics, reduction of reaction mechanisms and modeling of combustion systems, including: Conventional, alternative and surrogate fuels; Pollutants; Particulate and aerosol formation and abatement; Heterogeneous processes. Experimental, theoretical, and computational studies of laminar and turbulent combustion phenomena, including: Premixed and non-premixed flames; Ignition and extinction phenomena; Flame propagation; Flame structure; Instabilities and swirl; Flame spread; Multi-phase reactants. Advances in diagnostic and computational methods in combustion, including: Measurement and simulation of scalar and vector properties; Novel techniques; State-of-the art applications. Fundamental investigations of combustion technologies and systems, including: Internal combustion engines; Gas turbines; Small- and large-scale stationary combustion and power generation; Catalytic combustion; Combustion synthesis; Combustion under extreme conditions; New concepts.
期刊最新文献
A comprehensive parametric study on NO and N2O formation in ammonia-methane cofired premixed flames: Spatially resolved measurements and kinetic analysis Simultaneous Schlieren and direct photography of detonation diffraction regimes in hydrogen mixtures Elucidating high-pressure chemistry in acetylene oxidation: Jet-stirred reactor experiments, pressure effects, and kinetic interpretation A Bayesian approach to estimate flame spread model parameters over the cylindrical PMMA samples under various gravity conditions Ab initio intermolecular interactions mediate thermochemically real-fluid effects that affect system reactivity: The first application of high-order Virial EoS and first-principles multi-body potentials in trans-/super-critical autoignition modelling
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1