A study on in-situ characterization technology development for clearance verification of radioactive waste from nuclear decommissioning

Abstract

Although the clearance level of every radioactive nuclide was published by the IAEA to promote the recycling and reuse of decontaminated radioactive waste worldwide, technical and regulatory issues have always been raised around the application of the criteria. Therefore, several countries are developing in-situ characterization equipment or apparatus for on-site verification to check if the clearance criteria is met.

In this study authors developed a pilot radiation detection and measurement system using in-situ characterization technology to solve the issues, which consists of a 3D scanning camera system and a built-in Monte Carlo simulation program. Measurement results show that MDA (Minimum Detectable Activity) of the current design was indisputably below the clearance level and built-in Monte Carlo simulation package closely predicts the measurements results with the error of less than 5%. This implicates that it can determine with enough margin whether the radioactivity level of decontaminated metallic components meets the clearance criteria at decommissioning site or not.

Practically when we measure the radioactivity from gamma ray source mass attenuation always takes place during the photon transports through the medium. In fact, the reduction depends on the material, shapes, and radioactive sources. In this study the reduction factors were experimentally examined according to the influencing parameters and the results were saved as DCF (Density Correction Factor) in the data base. As expected, it turned out that the factor is somewhat affected by medium material and radioactive sources, but it is basically proportional to the distance of gamma ray passage.

It is expected that upgraded design with more accurate and reliable instruments can make it easier for regulators to accept the application of the in-situ characterization technology on-site.