Microstructural characteristics and mechanical properties of laser-welded Ta10W/GH3030 joints with beam offset

Abstract

Influences of the laser beam offset (LBO) on the microstructures as well as room-temperature and high-temperature mechanical properties of Ta10W/GH3030 dissimilar-material joints were investigated. In laser-welded Ta10W/GH3030 joints prepared under three conditions with LBOs of −0.2 mm (offset toward Ta10W), 0 mm, and + 0.2 mm (offset toward GH3030): the fusion zones (FZ) all contained expulsed substances Ni₃Ta, NiTa, and Cr₂Ta and their microhardness was certainly higher than the base metal (BM); a transition layer containing high contents of Ni₃Ta, NiTa, and Cr₂Ta phases was observed at the Ta10W/FZ interface. With the increase of the LBO, the contents of Ni₃Ta, NiTa, and Cr₂Ta in the FZ gradually declined, the average grain size in the FZ increased slightly, the microhardness of the FZ dropped rapidly, and the thickness of the transition layer at the Ta10W/FZ interface reduced obviously. Either in the room-temperature or high-temperature (750 °C) tensile tests, Ta10W/GH3030 joints were always fractured at the Ta10W/FZ interface, showing the typical brittle fracture mode, and the tensile strength of joints was enhanced with the increasing LBO. Under LBOs of −0.2, 0, and + 0.2 mm, the room-temperature tensile strengths of Ta10W/GH3030 dissimilar-material joints were 266.4, 308.6, and 341.2 MPa, while the high-temperature (750 °C) tensile strengths were 97.6, 191.5, and 202.7 MPa, respectively.