Investigation of the effects of heat treatment and hot isostatic pressing in micro-drilling of Ti6Al4V alloy fabricated by laser powder bed fusion

Abstract

In this study, micro-drilling performance of laser powder bed fusion (LPBF) Ti6Al4V alloy with heat treatment (HT) and hot isostatic pressing (HIP) post-processing conditions was investigated and compared to wrought material. The tests were performed at two spindle rotational speeds (5000 and 10,000 rev/min) and a feed per tooth (4 μm/tooth) under dry and minimum quantity lubrication (MQL) conditions using conventional drilling (CD) and peck drilling (PD) strategies. Micro-drilling performance was evaluated in terms of thrust force, surface roughness, subsurface microstructure and microhardness, burr formation, and tool wear. The test results showed that LPBF-HT and LPBF-HIP Ti6Al4V alloys exhibited different micro-drilling performances than the wrought material due to their different microstructural and mechanical properties. The LPBF-HIP Ti6Al4V characterized by higher strength and lamellar microstructure with higher β phase fraction (33.2 %) led to higher thrust force, lower surface quality and higher burr height. On the other hand, the wrought Ti6Al4V with higher ductility, lower hardness, and lower β phase fraction (16.3 %) showed lower thrust forces, surface roughness, and burr height. Notably, employing MQL conditions with the PD strategy provided good surface quality and reduced burr formation. A higher degree of tool wear was obtained in micro-drilling of LPBF-HIP Ti6Al4V. The major wear types were adhesion, BUE, and flank wear. Besides, chippings were observed in micro-drilling of LPBF-HT and LPBF-HIP Ti6Al4V.