A Frequency Synthesizer With Automatic Frequency Calibration Robust to Initial Phase Error and Phase-Noise Enhanced Ring Oscillator

IF 4.9 2区 工程技术 Q2 ENGINEERING, ELECTRICAL & ELECTRONIC IEEE Transactions on Circuits and Systems II: Express Briefs Pub Date : 2024-10-04 DOI:10.1109/TCSII.2024.3474018
Geonwoo Park;Ockgoo Lee;Donggu Im;Ilku Nam
{"title":"A Frequency Synthesizer With Automatic Frequency Calibration Robust to Initial Phase Error and Phase-Noise Enhanced Ring Oscillator","authors":"Geonwoo Park;Ockgoo Lee;Donggu Im;Ilku Nam","doi":"10.1109/TCSII.2024.3474018","DOIUrl":null,"url":null,"abstract":"An automatic frequency calibration robust to initial phase error and a phase-noise-enhanced ring oscillator are proposed for frequency synthesizers. The proposed automatic frequency calibration method can quickly determine the desired sub-band tuning curve for a voltage-controlled oscillator by detecting the overshoot voltage of the oscillator control voltage of the frequency synthesizer when an initial phase error occurs between the reference signal and the divided output signal from the oscillator, thereby reducing the locking time of the frequency synthesizer. The proposed ring oscillator uses a differential inverter type delay cell with an input AC-coupled current source for phase noise improvement and low power consumption. For verification, an integer-N frequency synthesizer with the proposed automatic frequency calibration and ring oscillator was fabricated using 65-nm CMOS technology. The implemented frequency synthesizer draws 2.5 mA from a 1-V supply voltage at a 1 GHz carrier frequency. It provides frequency calibration time of less than \n<inline-formula> <tex-math>$3.6~\\mu $ </tex-math></inline-formula>\ns, phase noise of –105.5 dBc/Hz at 1 MHz offset frequency of 1 GHz carrier frequency, and figure-of-merit for integrated jitter from 1 kHz to 1 MHz of –231 dBc/Hz.","PeriodicalId":13101,"journal":{"name":"IEEE Transactions on Circuits and Systems II: Express Briefs","volume":"72 1","pages":"43-47"},"PeriodicalIF":4.9000,"publicationDate":"2024-10-04","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"IEEE Transactions on Circuits and Systems II: Express Briefs","FirstCategoryId":"5","ListUrlMain":"https://ieeexplore.ieee.org/document/10705121/","RegionNum":2,"RegionCategory":"工程技术","ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q2","JCRName":"ENGINEERING, ELECTRICAL & ELECTRONIC","Score":null,"Total":0}
引用次数: 0

Abstract

An automatic frequency calibration robust to initial phase error and a phase-noise-enhanced ring oscillator are proposed for frequency synthesizers. The proposed automatic frequency calibration method can quickly determine the desired sub-band tuning curve for a voltage-controlled oscillator by detecting the overshoot voltage of the oscillator control voltage of the frequency synthesizer when an initial phase error occurs between the reference signal and the divided output signal from the oscillator, thereby reducing the locking time of the frequency synthesizer. The proposed ring oscillator uses a differential inverter type delay cell with an input AC-coupled current source for phase noise improvement and low power consumption. For verification, an integer-N frequency synthesizer with the proposed automatic frequency calibration and ring oscillator was fabricated using 65-nm CMOS technology. The implemented frequency synthesizer draws 2.5 mA from a 1-V supply voltage at a 1 GHz carrier frequency. It provides frequency calibration time of less than $3.6~\mu $ s, phase noise of –105.5 dBc/Hz at 1 MHz offset frequency of 1 GHz carrier frequency, and figure-of-merit for integrated jitter from 1 kHz to 1 MHz of –231 dBc/Hz.
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
一种具有自动频率校正、抗初始相位误差和相位噪声增强的环形振荡器频率合成器
提出了一种抗初始相位误差的自动频率校正方法和一种相位噪声增强环形振荡器。所提出的频率自动校准方法,通过检测频率合成器振荡器控制电压的超调电压,在参考信号与振荡器分频输出信号出现初始相位误差时,快速确定压控振荡器所需的子带调谐曲线,从而缩短了频率合成器的锁定时间。所提出的环形振荡器采用差分逆变器型延迟单元,输入交流耦合电流源,以改善相位噪声和降低功耗。为了验证,采用65纳米CMOS技术制作了具有自动频率校准和环形振荡器的整数n频率合成器。所实现的频率合成器在1 GHz载波频率下从1 v电源电压提取2.5 mA。它的频率校准时间小于$3.6~\mu $ s,在1 GHz载波频率的1 MHz偏移频率下相位噪声为-105.5 dBc/Hz,从1 kHz到1 MHz的集成抖动性能值为-231 dBc/Hz。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
IEEE Transactions on Circuits and Systems II: Express Briefs
IEEE Transactions on Circuits and Systems II: Express Briefs 工程技术-工程:电子与电气
CiteScore
7.90
自引率
20.50%
发文量
883
审稿时长
3.0 months
期刊介绍: TCAS II publishes brief papers in the field specified by the theory, analysis, design, and practical implementations of circuits, and the application of circuit techniques to systems and to signal processing. Included is the whole spectrum from basic scientific theory to industrial applications. The field of interest covered includes: Circuits: Analog, Digital and Mixed Signal Circuits and Systems Nonlinear Circuits and Systems, Integrated Sensors, MEMS and Systems on Chip, Nanoscale Circuits and Systems, Optoelectronic Circuits and Systems, Power Electronics and Systems Software for Analog-and-Logic Circuits and Systems Control aspects of Circuits and Systems.
期刊最新文献
IEEE Circuits and Systems Society Information Online Load Power Factor Angle Estimation and Its Application in a Current Sensor-Less Dead-Time Distortion Compensation Technique in Single-Phase PWM VSI With Lagging Load IEEE Circuits and Systems Society Information Table of Contents Incoming Editorial
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:604180095
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1