A study of the anisotropy of dimensional change in the compaction plane during sintering of low alloyed cold compacted steels

Abstract

ABSTRACT The anisotropy of dimensional change in compaction plane of rings made of three low alloyed steels was investigated as a function of green density and geometry. Increasing green density and (D ext–D int)/H ratio, the anisotropy of both shrinkage and swelling increases. A correlation with springback during ejection of the rings from die cavity after cold compaction was found. The ratio between the dimensional changes of diameters, as a function of the ratio between springback of diameters, describes a linear correlation intersecting point (1,1), representative of isotropic behaviour. This correlation confirms the hypothesis of an effect of micropores, generated in the green parts during ejection from die cavity, on dimensional change anisotropy. An analytical correlation was determined for the anisotropy of dimensional change in the compaction plane as a function of green density and geometrical parameter, which can be implemented in the design methodology accounting for the anisotropic dimensional change previously proposed.