Post preparation: cleanness achieved by different irrigating protocols.

Abstract

The aim of this study was to evaluate the ability of different irrigation protocols to remove from the walls of the root canal and entrance to dentinal tubules the smear layer produced during preparation for a fiber post. Fifty decoronated human lower premolars were treated endodontically and the apical third of the canal was filled with a single gutta-percha point using warm vertical compaction. Ten millimeters were left free for post preparation, which was done by sequential use of a Largo #1 drill and Exacto #3 pilot drill (Angelus, Brazil), with irrigation with distilled water upon each instrument change. Samples were distributed randomly into 5 groups (n=10). G 1: No irrigation after post preparation. G 2: Distilled water activated for 60 s + distilled water. G 3: 5.25% NaOCl 15 s+ distilled water. G 4: 17% EDTA (Farmadental, Argentina) 60 s + 5.25% NaOCl 15 s + distilled water. G 5: 10% polyacrylic acid (Densell) 15 s + distilled water. Irrigant was activated mechanically with a low-speed conical brush. Roots were then split longitudinally in vestibular-lingual direction. Each surface was observed under SEM in its different thirds. Microphotographs were taken at 150X and 600X magnification and results analyzed statistically using Kruskall Wallis and Friedman tests (p<0.05). The results [mean (standard deviation)] were: for 150X: G1 11.00 (1.33), G2 7.50 (3.13), G3 6.30 (2.58), G4 2.20 (2.80), G5 4.30 (1.50), and for 600X G1 11.40 (0.84), G2 10.00 (1.94), G3 7.70 (3.33), G4 5.80 (3.70), G5 7.20 (2.65). The statistical analysis showed significant differences between irrigants (p<0.05) but not between root thirds (p>0.05). The EDTA+NaOCl combination and polyacrylic acid showed greater capacity to remove the smear layer created during post preparation.