A Binary Liquid Mixture of Bioethanol-Water and Biodiesel-Water as Fuel for NSDC-LNSDCNSDC-L Direct Ethanol-Solid Oxide Fuel Cell

IF 1 Q4 CHEMISTRY, MULTIDISCIPLINARY Chemistry & Chemical Technology Pub Date : 2021-06-15 DOI:10.23939/CHCHT15.02.254
F. Rahmawati, Arum Putri Parameswari
{"title":"A Binary Liquid Mixture of Bioethanol-Water and Biodiesel-Water as Fuel for NSDC-LNSDCNSDC-L Direct Ethanol-Solid Oxide Fuel Cell","authors":"F. Rahmawati, Arum Putri Parameswari","doi":"10.23939/CHCHT15.02.254","DOIUrl":null,"url":null,"abstract":"This research studies the possibility on using a binary liquid mixture of bioethanol-water and biodiesel-water as fuel for a NSDC-LNSDCNSDC-L single fuel cell. The ratio of bioethanol-water was 70:30, as well as the ratio of biodiesel-water. The fuel vapor flowed into the fuel cell system under the temperatures of 673, 773 and 873 K with a flow rate of 1–1.5 ml•min-1. The highest power densities were found at 673 K which are 2.984 and 1.838 mW•cm-2 for bioethanol-water and biodiesel-water, respectively. It is a promising result for a single fuel cell test with a very low rate of liquid fuel flow. Meanwhile, open circuit voltage (OCV) of the single fuel cell with bioethanol-water fuel is 1.439 V which is close to the theoretical OCV. However, OCV of the single fuel cell with biodiesel-water as fuel is 0.710 V which is lower than the theoretical OCV. Cell polarization seems still being the problem causing voltage loss during single fuel cell test.","PeriodicalId":9793,"journal":{"name":"Chemistry & Chemical Technology","volume":null,"pages":null},"PeriodicalIF":1.0000,"publicationDate":"2021-06-15","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"0","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"Chemistry & Chemical Technology","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.23939/CHCHT15.02.254","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"Q4","JCRName":"CHEMISTRY, MULTIDISCIPLINARY","Score":null,"Total":0}
引用次数: 0

Abstract

This research studies the possibility on using a binary liquid mixture of bioethanol-water and biodiesel-water as fuel for a NSDC-LNSDCNSDC-L single fuel cell. The ratio of bioethanol-water was 70:30, as well as the ratio of biodiesel-water. The fuel vapor flowed into the fuel cell system under the temperatures of 673, 773 and 873 K with a flow rate of 1–1.5 ml•min-1. The highest power densities were found at 673 K which are 2.984 and 1.838 mW•cm-2 for bioethanol-water and biodiesel-water, respectively. It is a promising result for a single fuel cell test with a very low rate of liquid fuel flow. Meanwhile, open circuit voltage (OCV) of the single fuel cell with bioethanol-water fuel is 1.439 V which is close to the theoretical OCV. However, OCV of the single fuel cell with biodiesel-water as fuel is 0.710 V which is lower than the theoretical OCV. Cell polarization seems still being the problem causing voltage loss during single fuel cell test.
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
以生物乙醇-水和生物柴油-水二元液体混合物为燃料的NSDC- lNSDCNSDC- l直接乙醇-固体氧化物燃料电池
本研究研究了将生物乙醇-水和生物柴油-水的二元液体混合物作为NSDC- l燃料的可能性NSDCNSDC- l单燃料电池。生物乙醇与水的比例为70:30,生物柴油与水的比例为70:30。燃料蒸气在673,773和873 K的温度下以1-1.5 ml•min-1的流速流入燃料电池系统。673 K时,生物乙醇-水和生物柴油-水的最高功率密度分别为2.984和1.838 mW•cm-2。这是一个很有希望的结果,在一个单一的燃料电池试验,在极低的液体燃料流动速率。同时,生物乙醇-水燃料单体燃料电池的开路电压(OCV)为1.439 V,接近理论开路电压。而以生物柴油-水为燃料的单燃料电池的OCV为0.710 V,低于理论OCV。在单个燃料电池试验中,电池极化仍然是造成电压损失的主要问题。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
Chemistry & Chemical Technology
Chemistry & Chemical Technology CHEMISTRY, MULTIDISCIPLINARY-
CiteScore
1.70
自引率
44.40%
发文量
60
期刊最新文献
Synthesis of Heterocyclic Pyridine-Based Chalcones with Dimeric Structure Optimization of Epoxidation Palm-Based Oleic Acid to Produce Polyols Studying the Effect of Butanol on the Anode Behavior of Copper in Phosphoric Acid Solutions Telechelic Oligo(N-Vinylpyrolydone)swith Cumene Based Terminal Groups for Block-Copolymer and Nanoparticle Obtaining Nanotechnologies for Preparation and Application of Metallic Nickel
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1