High Lateral Resolution Auger Electron Spectroscopic (AES) Measurements for Sn Whiskers on Brass

M. Bozack, E. R. Crandall, C. L. Rodekohr, R. Dean, G. Flowers, J. Suhling
{"title":"High Lateral Resolution Auger Electron Spectroscopic (AES) Measurements for Sn Whiskers on Brass","authors":"M. Bozack, E. R. Crandall, C. L. Rodekohr, R. Dean, G. Flowers, J. Suhling","doi":"10.1109/TEPM.2010.2048217","DOIUrl":null,"url":null,"abstract":"We report high lateral resolution Auger electron spectroscopic (AES) measurements on high aspect ratio Sn whiskers. The whiskers were grown from compressively stressed thin films (~ 6000 Å) of Sn on brass using a magnetron sputtering system. The Auger spectra show that, after sputter cleaning, the whisker is nearly 100% Sn at all locations along the whisker shaft, at the growing blunt end of the shaft, and with depth (~ 1000 Å) into the side of the whisker. The “as received” Sn whisker surface shows the expected ~ 200 Å of native Sn oxide at all locations and the O signal nearly disappeared (~ 3 atom%) after 200 Å of sputter cleaning. There was no evidence of high amounts of oxygen within the bulk of the whisker. That brass is not observed in the whisker shaft supports the notion that whisker formation is accompanied by material mass transport through interfaces and grain boundaries which causes stress (usually compressive) relief. This is supported by the most remarkable aspect of the whisker growth; namely, that high aspect ratio Sn whiskers ~ 100-500 μm in length containing no brass can be grown from a ~ 0.6 μm thin film of Sn.","PeriodicalId":55010,"journal":{"name":"IEEE Transactions on Electronics Packaging Manufacturing","volume":"39 1","pages":"198-204"},"PeriodicalIF":0.0000,"publicationDate":"2010-05-24","publicationTypes":"Journal Article","fieldsOfStudy":null,"isOpenAccess":false,"openAccessPdf":"","citationCount":"11","resultStr":null,"platform":"Semanticscholar","paperid":null,"PeriodicalName":"IEEE Transactions on Electronics Packaging Manufacturing","FirstCategoryId":"1085","ListUrlMain":"https://doi.org/10.1109/TEPM.2010.2048217","RegionNum":0,"RegionCategory":null,"ArticlePicture":[],"TitleCN":null,"AbstractTextCN":null,"PMCID":null,"EPubDate":"","PubModel":"","JCR":"","JCRName":"","Score":null,"Total":0}
引用次数: 11

Abstract

We report high lateral resolution Auger electron spectroscopic (AES) measurements on high aspect ratio Sn whiskers. The whiskers were grown from compressively stressed thin films (~ 6000 Å) of Sn on brass using a magnetron sputtering system. The Auger spectra show that, after sputter cleaning, the whisker is nearly 100% Sn at all locations along the whisker shaft, at the growing blunt end of the shaft, and with depth (~ 1000 Å) into the side of the whisker. The “as received” Sn whisker surface shows the expected ~ 200 Å of native Sn oxide at all locations and the O signal nearly disappeared (~ 3 atom%) after 200 Å of sputter cleaning. There was no evidence of high amounts of oxygen within the bulk of the whisker. That brass is not observed in the whisker shaft supports the notion that whisker formation is accompanied by material mass transport through interfaces and grain boundaries which causes stress (usually compressive) relief. This is supported by the most remarkable aspect of the whisker growth; namely, that high aspect ratio Sn whiskers ~ 100-500 μm in length containing no brass can be grown from a ~ 0.6 μm thin film of Sn.
查看原文
分享 分享
微信好友 朋友圈 QQ好友 复制链接
本刊更多论文
黄铜上锡晶须的高横向分辨率俄歇电子能谱(AES)测量
我们报道了高纵横比Sn晶须的高横向分辨率俄歇电子能谱(AES)测量。利用磁控溅射系统,在黄铜表面的压缩应力薄膜(~ 6000 Å)上生长出晶须。俄歇光谱表明,在溅射清洗后,晶须沿晶须轴的所有位置、晶须轴的生长钝端以及晶须侧面的深度(~ 1000 Å)都接近100%的Sn。接收到的Sn晶须表面在所有位置都显示出预期的~ 200 Å天然氧化锡,并且在200 Å溅射清洗后O信号几乎消失(~ 3原子%)。没有证据表明,在大部分的晶须中含有大量的氧气。在晶须轴中没有观察到黄铜,这支持了晶须形成伴随着物质通过界面和晶界的传输,从而导致应力(通常是压缩)缓解的概念。这一点得到了晶须生长最显著方面的支持;即在~ 0.6 μm的Sn薄膜上生长出长度为100 ~ 500 μm且不含黄铜的高长宽比Sn晶须。
本文章由计算机程序翻译,如有差异,请以英文原文为准。
求助全文
约1分钟内获得全文 去求助
来源期刊
自引率
0.00%
发文量
0
期刊最新文献
Board-Level Vibration Failure Criteria for Printed Circuit Assemblies: An Experimental Approach Editorial - CPMT Society to Merge Transactions in 2011 An Integrated Manufacturing System for the Design, Fabrication, and Measurement of Ultra-Precision Freeform Optics Signal Integrity Enhanced EBG Structure With a Ground Reinforced Trace Reducing Solder Paste Inspection in Surface-Mount Assembly Through Mahalanobis–Taguchi Analysis
×
引用
GB/T 7714-2015
复制
MLA
复制
APA
复制
导出至
BibTeX EndNote RefMan NoteFirst NoteExpress
×
×
提示
您的信息不完整,为了账户安全,请先补充。
现在去补充
×
提示
您因"违规操作"
具体请查看互助需知
我知道了
×
提示
现在去查看 取消
×
提示
确定
0
微信
客服QQ
Book学术公众号 扫码关注我们
反馈
×
意见反馈
请填写您的意见或建议
请填写您的手机或邮箱
已复制链接
已复制链接
快去分享给好友吧!
我知道了
×
扫码分享
扫码分享
Book学术官方微信
Book学术文献互助
Book学术文献互助群
群 号:481959085
Book学术
文献互助 智能选刊 最新文献 互助须知 联系我们:info@booksci.cn
Book学术提供免费学术资源搜索服务,方便国内外学者检索中英文文献。致力于提供最便捷和优质的服务体验。
Copyright © 2023 Book学术 All rights reserved.
ghs 京公网安备 11010802042870号 京ICP备2023020795号-1