Improving Thin Strip Profile Using Work Roll Cross and Work Roll Shifting Methods in Cold Strip Rolling

Abstract

The optimization of rolling parameters in order to achieve better strip shape and to reduce rolling force is a challenge in rolling practice. In this paper, thin strip asymmetrical rolling of aluminum at various speed ratios under lubricated condition has been investigated at various combinations of work rolls cross (WRC) angles and work rolls shifting (WRS) values. The effects of strip width, reduction, and rolling speed on strip shape taking WRC and WRS into consideration are discussed. Results show that strip profile improves significantly when the WRC angle is increased from 0° to 1°, with an associated reduction in rolling force. Increasing WRS value from 0 to 8 mm improves the strip profile as well but not as significantly as when WRC angle is increased. No significant improvement was found in strip shape when the strip width was increased. At higher reduction, the strip shape was improved; a decrease in the rolling force was also observed. A higher speed ratio was found to be effective only at a higher WRC angle. The effect of lubrication on the strip profile was significant. Results indicate that an optimum combination of WRC, WRS, reduction, width, and speed ratio under lubricated conditions can ensure an improved exit strip profile, reduce rolling force, and obtain a better quality strip.