Choice of a method of carbon wire drawing

At present for wire production various methods of drawing are used. To choose an effective drawing method or their combination, a methodology is needed to estimate existing and new methods of drawing. A methodology of simultaneous estimation of strain-stress state of carbon wire in the area of deformation and force conditions of drawing presented. Based on it an analysis of drawing in monolith dies, roller dies of radial-shear broach, classic two- and multi-roller dies was carried out. A module-combined method of drawing was also considered. Recommended modes of reduction for drawing in monolith dies presented. It was shown that to obtain a wire of 4.0 mm diameter max, the drawing in monolith dies is most effective. For production of wire of larger diameters, roller dies are more advisable. Application of the technology of radial-shear deformation enables to obtain a fine-grained structure in the surface layers of wire. It was shown that application of a module comprising a roller die and a monolith die is most effective. An example of drawing of a round wire from 8.0 mm diameter to 3.0 mm diameter by a route developed with their application considered. Recommendations on application of various methods of drawing for wires of diameter from 0.007 mm to 15.0 mm presented.