Possibilities of increasing production efficiency by implementing elements of augmented reality

. The publication reflects the current situation concerning the possibilities of using augmented reality (AR) technology in the field of production technologies with the main intention of creating a tool to increase production efficiency. It is a set of individual steps that respond in a targeted manner to the possible need for assisted service intervention on a specific device. The publication chronologically describes the procedure required for the preparation and processing of a CAD model. For this preparatory process, the PTC software package is used which meets the requirements for each of the individual operations. The first step is the routine preparation of CAD models and assemblies. These are prepared based on real models located on the device, and their shape and dimensions correlate with the dimensions of the model on the device. The second phase is the creation and timing of the disassembly sequence. This will provide the model with complete vector data, which is then paired with the CAD models in AR. This phase is one of the most important. It determines the location of the model concerning its relative position on the device, provides information on the relocation of parts of the model after the sequence is started, and essentially serves as a template for the interactive part of the sequence. The last two phases are used to connect CAD models with vector data, determine their position for the position mark, and prepare the user interface displayed on the output device. The result of this procedure is a functional disassembly sequence, used for assisted service intervention of a worker in the spindle drive of the Emco Mill 55 device.