The Effect of Multiple Cycles of Surfactant-Alternating-Gas Process on Foam Transient Flow and Propagation in a Homogeneous Sandstone

Summary Years of laboratory studies and field tests show that there is still uncertainty about the ability of foam to propagate deep into a reservoir. Many factors have been identified as potential causes of nonpropagation, the most concerning being the lack of sufficient pressure gradient required to propagate foam at locations far from the point of injection. Most researchers that investigated foam propagation did so by coinjecting surfactant and gas. Coinjection offers limited information about transient foam processes due to limitations in the experimental methods needed to measure foam dynamics during transient flow. Foam injection by surfactant-alternating-gas (SAG) has proven to be more effective and common in field application. Repeated drainage and imbibition cycle offer a more favorable condition for the quick generation of foam. Foam can also be propagated at a lower pressure gradient in SAG mode. The objective of this study is to experimentally investigate how transient foam dynamics (trapping, mobilization, and bubble texture) change with multiple cycles of SAG and also with distance from the point of injection. A pair of X-ray source and receiver, differential pressure transducers, and electrical resistance sensors were placed along a 27-cm long, homogeneous, and high-permeability (KL = 70 md) Berea sandstone core. Foam was then generated in situ by SAG injection and allowed to propagate through the core sample under a capillary displacement by brine (brine injection rate = 0.5 cm3/min, Nca = 3×10-7). By use of a novel analytical method on coreflood data obtained from axial pressure and saturation sensors, we obtained trapped foam saturation, in-situ foam flow rates, apparent viscosities, and inferred qualitative foam texture at different core sections. We then observed the following: (i) Maximum trapped foam is uniform across the core sections, with saturation ranging from 47% to 52%. At the vicinity of foam injection, foam apparent viscosity is dominantly caused by gas trapping. At locations farther away, foam apparent viscosity is dominated by both gas trapping and refinement of foam texture. (ii) Cyclic injection of foam further enhances the refinement of foam texture. (iii) Textural refinement increases foam apparent viscosity as it propagates away from the point of injection. (iv) As the foam strength increases, the average gas flow rate in the core sample decreases from 0.5 cm3/min to 0.06 cm3/min. (v) There is no stagnation of foam as remobilization of trapped gas occurs during each cycle at an average flow rate of 0.002 cm3/min.