Small-Scale Diffusion Dryer on an Optical Particle Counter for High-Humidity Aerosol Measurements with an Uncrewed Aircraft System

The negative effects of relative humidity to measurements of particulate matter (PM) due to hygroscopic growth are often not inherently handled by low-cost optical particle counters (OPCs). This study presents a new approach in constructing a miniaturized diffusion dryer, for use with an OPC mounted on an uncrewed aircraft system (UAS), namely, the DJI S900 (weight of 7.5 kg and flight endurance of 20 min) for short-term measurements under humid conditions. In this work, an OPC of type N3 (Alphasense) was employed alongside the dryer, with experiments both in the laboratory and outdoors. Evaluation of the dryer’s performance in a fog tank showed effective drying from almost saturated air to 41% relative humidity for 35 min, which is longer than the endurance of the UAS, and therefore sufficient. Changes in the flow rate through the OPC-N3 with the dryer showed a 17% reduction compared to an absent dryer, but the measured PM values remained unaffected. Airborne measurements were taken from four hovering flights near a governmental air pollution station (Mannheim-Nord, Germany) under humid conditions (88%–93%) where the system gave agreeable concentrations when the dryer was in place, but significantly overestimated all PM types without it. At a rural area near the Boundary Layer Field Site Falkenberg (Lindenberg, Germany), operated by the German Meteorological Service (DWD), vertical profiles inside a low-altitude cloud showed sharp increase in concentrations when the UAS entered the cloud layer, demonstrating its capability to accurately detect the layer base.