Influence of reduction parameters on, weight loss, crack propagation, iron whisker growth, and morphological characteristics of directly reduced iron produced by non-contact direct reduction process

Non-contact direct reduction (NDR) is an alternative technique in iron and steelmaking. Direct reduced iron production (DRI) uses it. To further harness the metallurgical and operational capabilities of the process for its suitability as an alternative feed in the blast furnace process, there is a need to study the effect of the reduction parameters on the weight loss, crack propagation level, gas porosity, iron whisker growth, and morphological characteristics of the DRI. Thus, this paper attempts to utilize the NDR process using commercially acquired goethite-hematite ore in a carbon-monoxide atmosphere from wood charcoal under specified isothermal conditions, with a reduction temperature range from 570, 800, and 1000 °C. The effect of reduction parameters on weight loss, crack propagation, iron whisker growth, and morphological properties of the DRI was investigated using standardized reduction reaction practices under a nitrogen gas atmosphere with a flow rate of 120 mL. Mineralogical and morphological analyses of the direct reduced iron (DRI) and charcoal were performed using XRF and SEM/ED analysis. Proximate and ultimate analyses of the reductant were performed to ascertain their physical and chemical properties. The results show that reduction parameters tremendously influence the weight loss, crack propagation, gas porosity level, and metallurgical quality of the DRI. The reduction degree and swelling extent of the DRI also increase with crack propagation and iron whisker growth. Thus, the overall reduction mechanism still follows the usual stepwise chronological reduction order (Fe₂O₃ → Fe₃O₄ → FeO → Fe) regardless of temperature, with ash layer control being the reaction rate control. The NDR technique shows no carbon deposition in the DRI metal matrix. It indicates that this approach can serve as a viable alternative for DRI production in the ironmaking process.