Application of seismic refraction and MASW methods for investigating the Spillway Fault trace along the western side of the Aswan High Dam, Egypt

An earthquake of local magnitude M_L = 4.6 occurred on November 7, 2010, 4.5 km northwest of the Aswan High Dam on the Spillway Fault. In the Aswan metropolitan region this earthquake was felt intensely. As no surface rupture was found, the focal mechanism and the distribution of seismic activity was one of the tools used for finding fault dimensions. The composite fault-plane solutions for the observed events on the Spillway Fault showed a left lateral strike-slip faulting with normal-fault component striking NNW-SSE. Also, remote sensing techniques were applied for the detection and identification of the geomorphology and geometry of the Spillway Fault. In this research, sub-surface layers and structures are delineated utilizing near-surface seismic techniques. Furthermore, the area’s supposed path and position of the Spillway Fault are also investigated. Two active seismic techniques, Seismic Refraction and Multi-Channel Analysis of Surface Waves (MASW), are utilized for recording near-surface seismic wave data at 9 sites. The seismic refraction profiles are conducted as a 2D cross-section on the trace of the detected Spillway Fault in the study area to evaluate the maximum depth of penetration of the P-wave for fault investigation. The constructed 2D seismic and structural sections from P-wave results show that the obtained average depth of about 30 m. In addition, the estimated P-wave velocities extend from 600 m/s to over 6500 m/s. Some lateral variation in the seismic wave velocities in all layers may represent fault zones. Moreover, the 1D MASW technique is conducted to estimate the velocities of the shear wave for the upper 30 m (Vs30) to provide the site classes and soil characteristics along both sides of the detected Spillway Fault trace in the study area. The calculated Vs30 values emphasized the idea of the existence of a normal dip-slip fault trace which divides the study area into two different lithological parts. The first part is located on the eastern side and characterized by almost class B (hard rock, according to NEHRP classification), while the other part is located to the west, and shows almost class type C (denoted as dense soil and soft rock soil).