Experimental study of a novel guided sequential immersion cooling system for battery thermal management

Immersion cooling exhibits superior cooling performance compared to traditional battery thermal management systems (BTMS). However, a significant challenge of immersion cooling is the spatial variation of temperature within both the coolant and lithium-ion batteries (LIBs). This research proposes a guided sequential immersion cooling (GSIC) BTMS to address this issue. Experimental studies were conducted to evaluate the heat dissipation performance of the GSIC structure under various conditions, including extreme loads. The results indicate that under the static flow immersion cooling (SFIC) scheme, cooling the tabs significantly influences the overall performance. Immersing the tabs can reduce the maximum battery temperature by 10.403 °C, although the spatial variation of temperature persists. Under forced flow immersion cooling (FFIC) conditions, increasing the coolant flow rate dissipates the heat generated by LIBs more effectively. Even at an extreme discharge rate of 5C, the maximum temperature remains below 45 °C. The average temperature reduction at the tabs is greater than the battery body, and with increased flow rates, the temperature difference between the two can be maintained within 1 °C under all conditions. As the flow rate keeps increasing, the average temperature at the tabs gets even lower than the battery body at low loads. This demonstrates that the GSIC BTMS can suppress the temperature rise at the tabs, which is a critical heat risk. Moreover, the temperature uniformity of the LIBs module is improved. As the flow rate increases, the temperature difference within the LIBs module decreases when the discharge rates is between 1C and 5C. Theoretical analysis confirms that increasing flow rates for low loads can suppress temperature rise, albeit with increased power consumption and reduced cooling efficiency. High flow rates are more suitable for high load conditions of the LIBs. These results validate the feasibility of the GSIC BTMS and provide new insights for the development of immersion cooling BTMS.