Numerical analysis of gas-solid flow erosion in different geometries as alternatives to a standard pipe elbow

This study was conducted with the aim of replacing different geometric fittings instead of the standard 90° elbow and trying to change the flow pattern to reduce erosion damage. Among fittings, the elbows are at a more serious risk. Numerical investigation of the present erosion with the novelty of research on non-spherical particles and changes in the impact angle of particles along with fluid flow using eight new proposed fittings, including two miter fittings, three blinded fittings, one reducer elbow fitting, and two spherical elbows fittings in comparison with the standard 90° elbow was controlled. The numerical simulation of the gas-solid two-phase flow of non-spherical particles was studied using the Euler-Lagrange approach. To carry out the study numerical, first, the gas flow was modeled by the Navier-Stokes equations and the turbulent Reynolds stress model, and then the solid particles were injected using Newton's equation. Finally, the erosion was calculated using Grant and Tabakoff model of the restitution of particles of after hitting the wall and the erosion model of Oka. The amount of erosion caused by changes in the flow pattern was investigated to evaluate the performance of the new proposed fittings. Numerical results for the most critical mode (V_in = 27 m/s and D_P = 300 μm) showed that the new proposed fittings increase the erosion resistance by 22.5 % to 39.6 % compared to the standard 90° elbow. Also, in this research, the effect of different parameters including flow velocity, particle diameter size, particle input rate, and particle rotation on erosion were investigated.